PORSCHE DESIGN 911 User Manual

PLH | Porsche Lizenz- und Handelsgesellschaft mbH & Co. KG
Grönerstraße 5 | 71636 Ludwigsburg | Deutschland
Declaration
Déclaration
Caution
This device complies with Part 15 of the FCC Rules / Industry
Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
MPE Reminding
To satisfy FCC / IC RF exposure requirements, a separation
distance of 20 cm or more should be maintained between the
antenna of this device and persons during device operation. To
ensure compliance, operations at closer than this distance is
not recommended.
A
ttention
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Conformément à la réglementation d'Industrie Canada, le
présent émetteur radio peutfonctionner avec une antenne d'un
type et d'un gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte
que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne
dépasse pas l'intensité nécessaire à l'établissement d'une
communication satisfaisante.
MPE Avis
Les antennes installées doivent être situées de facon à ce que
la population ne puisse y être exposée à une distance de moin
de 20 cm. Installer les antennes de facon à ce que le personnel
ne puisse approcher à 20 cm ou moins de la position centrale
de l’ antenne.
La FCC des éltats-unis stipule que cet appareil doit être en tout
temps éloigné d’au moins 20 cm des personnes pendant son
functionnement.

PORSCHE DESIGN 911 Specifications

General

Brand	Porsche Design
Model	911
Category	Speakers
Total Output Power	60 W
Frequency Response	60 Hz - 20 kHz
Inputs	3.5mm AUX
Bluetooth	Yes
aptX	Yes
Connectivity	Bluetooth

Summary

Declaration

FCC and Industry Canada Compliance

Device compliance with FCC Rules and Industry Canada standards.

RF Exposure and MPE Reminding

Safety guidelines for RF exposure and minimum separation distances.

Safety Advice

General Precautions

Key safety instructions for positioning, operation, and maintenance.

Electrical and Environmental Safety

Warnings regarding wet hands, power cords, heat, and disposal.

Important Safety Instructions

Operational and Environmental Guidelines

Instructions for operating environment, altitude, moisture, and sunlight.

Electrical Safety and Cord Protection

Precautions for shock, wet hands, power cord protection, and grounding.

Battery Safety Warnings

Warnings about battery hazards, explosion risk, and correct replacement.

Additional Safety Notices

Battery and Small Part Hazards

Warnings about battery ingestion, proper disposal, and choking hazards.

Safety Symbols and Ratings

Explanation of symbols like Class II protection and important literature alerts.

Unpacking and Initiating

Contents Check

List of items included in the package for verification.

Initial Setup and Break-in

Procedure for initial setup and break-in period for sound quality.

Installation

Positioning Guidelines

Instructions for placing the 911 Soundbar on a flat surface.

Authenticity of Materials

Explanation regarding unique characteristics of the 911 GT3 silencer used.

Connecting Your 911 Soundbar

Optical Digital Input

Connecting the TV via optical audio output (Toslink) for optimal quality.

Coaxial Digital Input

Connecting Blu-Ray/DVD players via coaxial digital output.

Analogue AUX Input

Connecting TVs or other devices using RCA cables to the analogue input.

Subwoofer Analogue Output

Connecting an external active subwoofer via the SUB OUT port.

Operation

Basic Controls

Explanation of power, standby, mute, volume, and input selection functions.

Sound and Playback Modes

Details on sound modes (Stereo, Surround) and Bluetooth pairing.

Memory Function

How settings are retained after power disconnection.

Display Indications

Input and Sound Mode Indicators

Meanings of displays for input selection and sound modes.

Play Mode and Bluetooth Status

Displays for playback modes and Bluetooth connection status.

Extended Sound Functions

Playback Adjustment

Controls for LipSync, subwoofer output, EQ, and DRC.

Extended Sound Functions (continued)

Volume Limiting and Voice Enhancement

Functions for setting volume limits and improving speech intelligibility.

Set-up Functions

Automatic On/Off Function (AUT)

Automatic power on/off based on signal detection.

Eco Standby Function (ECO)

Automatic standby mode after inactivity to save power.

Automatic BT Input Selection

Automatic Selection [AUT]

Automatically switches to BT input when audio signal is detected.

Manual Selection [MAN]

Requires manual input selection; device supplied in this mode.

IR Learning Function

Learning TV Remote Commands

Process to learn infrared codes from a TV remote control.

Allocating Functions to Keys

Process of assigning specific functions to TV remote keys.

IR Learning and Control

Direct Input Selection Setup

Assigning specific input sources (TV, DVD, AUX, BT) to TV remote keys.

IR Delete Function

Clearing Learned IR Codes

Procedure to delete previously learned TV remote control commands.

Troubleshooting

Power, Remote and Sound Issues

Solutions for power, remote, sound volume, and no audio problems.

Hum and Bluetooth Connectivity Problems

Diagnosing hum, Bluetooth playback, and input selection issues.

Troubleshooting (continued)

Automatic Functionality Problems

Addressing issues with automatic on/off and BT input switching.

Technical Specifications

Power and Input/Output Details

Electrical specifications for power supply, consumption, and audio levels.

Decoder, Virtualiser, and Bluetooth Specs

Details on supported audio decoders, virtualiser technology, and Bluetooth parameters.

Ambient Temperature Range

Recommended operating temperature limits for the device.

Further Information

Normal Use and Operation Advice

Guidelines for indoor use, modifications, and power source.

Environmentally Friendly Operation

Tips for minimizing electricity usage and standby modes.

CE Marking and Disposal

Information on CE compliance and proper disposal of the device and batteries.

Licensing Information

Dolby Digital and DTS Licensing

Information regarding licenses for Dolby Digital and DTS technologies.

Bluetooth and aptX Licensing

Details on trademarks and licenses for Bluetooth and aptX technologies.