Porsche 912 E - Page 21

Engine, Crankcase
10
DISMAN.TLING AND ASSEMBLING ENGINE/TRANSMISSION ASSEMBLY
Dismantling
1. Remove wire at starter and backup light switch.
2. Loosen engine mounting bolt and nuts.
3. Pull transmission off engine.
);.,.,_.._
Printed in Germany
Assembling
Note the following points.
1. Apply a coat of all purpose grease with MoS
2
to
all bearing surfaces of the clutch release
as well as the splines of the input shaft. '\
2. Place transmission on engine.
3. Torque engine mounting bolt and nuts to
47 Nm
(4. 7 kpm).
Removing and Installing Engine
10 - 7