What to do if the Portek Log Splitter motor does not run?
If the Portek Log Splitter's motor isn't running, first, ensure the splitter is properly plugged in. If it is, check if the motor Reset has tripped and push the Reset Button. Also, the circuit breaker might need to be reset. If the electric cable is damaged, do not use the unit until it has been checked by a competent electrician.
Why my Portek Log Splitter does not have full splitting power?
If your Portek Log Splitter doesn't seem to have full splitting power, ensure the extension cable is no more than 10m long and is not smaller than 1.5mm2 wire. Longer extensions will need a higher rating. Also, check the belt for slipping or damage and replace it if necessary.
Why does the Portek CHARGER motor reset continuously trip?
If the motor Reset continuously trips on your Portek Log Splitter, the extension cable might be too long or incorrectly rated. Ensure that the cable is no more than 10m long and is not smaller than 1.5mm2 wire. Longer extensions will need a higher rating.
General| Brand | Portek |
|---|---|
| Model | CHARGER |
| Category | Log Splitter |
| Language | English |
Rules for safe operation and warnings regarding hazards.
Mandatory safety gear required for operating the log splitter.
Instructions for moving and preparing the machine at the work area.
Key procedures and warnings for safe and correct machine operation.
Technical details including size, power, capacity, and weight.
To Next Page