10
Once you have started the engine, allow
the engine to carry out 'Idle Operation'
of 5 minutes to give the Post Driver time
to reach correct operating temperature.
When the engine is warm, press the
'Throttle Switch' to the appropriate
operating position according to the
required impact power.
The Post Driver should be run at low or
medium-speed in the first 20 hours of
operation and in order to extend the
service life of the machine.
The Post Driver should not be run at
high-speed during operation.
Operation
Stopping
To stop the Post Driver, release the
'Throttle Switch' and carry out idle
running of the machine for 3-5 minutes.
Then pull the 'Stop Switch' to the stop
position.
Combination
Switch
Throttle
Switch
Stop
Switch
STOP
To Next Page
Loading...
