What to do if the display is flashing on Porter & Charles SOSS 60?
If the Porter & Charles oven display is flashing, only partially illuminated, or cycling through various displays, switch off the power supply to the appliance. Wait for 30 seconds, then turn the power back on and reset the clock.
Why is there no heat in my Porter & Charles Oven?
If your Porter & Charles oven has power but isn't heating up, it might be set to AUTO mode, the oven temperature could be set to OFF, or the mode selection might be incorrect. Check these settings to ensure the oven heats properly.
What to do if Porter & Charles SOSS 60 Oven power is on but appliance does not operate?
If your Porter & Charles oven has power but isn't operating, it may be set on AUTO. Check the auto programmed cooking settings.
How to check power supply to Porter & Charles SOSS 60 Oven?
If there is no power supplied to your Porter & Charles oven, check if the power has been disconnected. Also, inspect the meter box and see if the main fuse or circuit breaker has blown or tripped.
Why does the rubber seal have gaps at the bottom of my Porter & Charles SOSS 60 Oven?
The gaps in the rubber seal of your Porter & Charles oven doors are there for oven venting purposes. This is normal.
General| Brand | Porter & Charles |
|---|---|
| Model | SOSS 60 |
| Category | Oven |
| Language | English |
To Next Page