To Next PageTo Next Page
Need help?Do you have a question about the Porter-Cable 7406 and is the answer not in the manual?
General| Weight | 8.2 lbs |
|---|---|
| Voltage | 120V |
| Wheel Diameter | 6 inches |
| O.P.M. | 1750 opm |
| Spindle Thread | 5/8-11 |
| Spindle Size | 5/8 inch |
Guidelines for maintaining a clean and safe work environment.
Precautions for safe use of electrical power and tools.
Operator safety measures, alertness, and avoiding distractions.
Advice on clothing and jewelry to prevent entanglement with moving parts.
Steps to prevent unintended tool activation before use.
Recommendation to wear protective gear like goggles and masks.
Methods for stabilizing the workpiece for safe operation.
Advice on using the correct tool for the job and avoiding strain.
Tips for keeping tools sharp, clean, and in good condition.
Importance of using manufacturer-approved accessories for safety.
Emphasizes that service must be performed by qualified repair personnel.
Stress on using identical replacement parts for tool servicing.
Safety measure to avoid shock from hidden wiring.
Requirement to use guards for operator protection from debris.
Ensure accessories match or exceed tool speed ratings for safety.
Warning against sanding lead-based paint due to health risks.
Prohibition of using woodcarving blades on this grinder.
Keep the work area well-ventilated during paint removal.
Cover or remove carpets, furniture, and clothing from the work area.
Place drop cloths to catch paint chips and wear protective clothing.
Isolate work areas and seal off doorways to contain dust.
Keep children and pregnant women away from the paint removal area.
Use approved respirators, not disposable paper masks, for protection.
Prohibits food, drink, smoking, or chewing gum in the work area.
Wet mopping to clean paint chips and dust using detergent.
Bag and dispose of paint chips and debris securely.
Remove and wash work clothes separately to avoid spreading dust.
Step-by-step instructions on operating the power switch.
Instructions for attaching the auxiliary handle for better control.
Steps for mounting the wheel guard securely.
Positioning and securing the guard for operator safety.
Detailed steps for fitting the grinding wheel onto the spindle.
Correct placement of the inner flange for Type 1 blades.
Instructions for fitting the outer flange for different wheel types.
Steps for attaching the sanding backup pad and abrasive disc.
Securing the backup pad and abrasive disc to the spindle.
Proper technique for operating the grinder with guards and handle.
Instructions for cleaning plastic parts and air passages.
Checks for common issues when the tool does not start.
Information that the tool requires no further lubrication.
Guidance on professional brush inspection and replacement.
Details on professional servicing and guarantees.
Specifies RPM rating and guard usage for accessories.
