27
3. If you’re replacing a tag for an unassigned
pet, discard the old tag when the new tag
arrives. Follow lithium mangnese dioxide
coin cell battery recycling and disposal
regulations for your state or municipality.
4. Attach the new tag by slipping the tag ring onto
the D-ring on your unassigned pet’s collar.
5. If you’re replacing a tag for an assigned pet,
you will need to perform a factory reset of your
PortionPro Rx to clear the old tag from the feeder
memory and pair the new tag (see steps below).
6. When the new tag arrives, remove the old tag
from the assigned pet’s collar and discard.
7. Place the new tag at least 3 feet away from
the PortionPro Rx and keep it there.
8. Write down your existing settings for
easy programming. Perform a factory
reset by first unplugging the feeder. Next,
hold while plugging your PortionPro Rx
back into the wall outlet. Once the feeder is
plugged in again, release the button.
9. All current settings will be erased and the LCD
screen will display the original setup screen,
allowing you to select from the available options
starting with Set Current Time. Follow the “Next
Select” prompts for all steps, including pairing
the new tag for use with this PortionPro Rx.
If you have additional assigned tags for this
PortionPro Rx, you will also need to reassign them
for use with this feeder.
All Other Codes
If any other alert codes appear on your LCD screen
with an alert tone, please call Vet Innovations at
877-VET-PPRx (877-838-7779) for assistance.
To Next Page
Loading...