JETSTREAM USER MANUAL
13
Assembly
• The rst stage on a Jetstream Classic
has four (4) low pressure ports and two
(2) high pressure ports. These different
types of ports are marked with R/LP for
the low pressure ports and HP for the
high pressure ports. The port marked
with R has a slightly higher ow rate
then the other low pressure ports and
this is the port where you preferably
mount your primary second stage.
• The rst stage of a Jetstream Mk3 has
ve (5) low pressure ports and two (2)
high pressure ports. These different
types of ports are marked with IP for
low pressure ports and HP for high
pressure ports. All low pressure ports
provide the same airow.
• Low and high pressure ports have
different thread size to avoid accidently
mounting components in the wrong
port. If a hose connection does NOT t
in a port, do not use force/violence to
connect the hose to the port. This could
lead to accidents and injury.
• Jetstream Mk3 is delivered with a hose
adapter that makes it possible to use a
low pressure hose with a 9/16”
connection. It is possible to update a
Jetstream Classic with this hose
adapter (accessory) but if this is done,
make sure the rst stage used is
equipped with an over pressure valve.
Before you assemble your Jetstream regulator, please pay attention to the following:
Low- and high pressure ports,
Jetstream Classic
Hose connection,
Jetstream Mk3
Low- and high pressure ports,
Jetstream Mk3
To Next Page
Loading...