Possl Campstar - Care; External Care; Interior Care

Care
12
54 Campstar - 03/23-0 - PSL-MJ23-00EN
12Care
12.1 External care
12.1.1 Washing with a high-pressure cleaner
Before cleaning the vehicle with a high-pressure cleaner, observe the opera-
ting instructions of the high-pressure cleaner.
When cleaning with the nozzle for circular jet between the vehicle and the
cleaning nozzle, maintain a minimum distance of approx. 700 mm.
Take into consideration that the jet of water comes out of the cleaning nozzle
with pressure. The vehicle may be damaged by incorrect handling of the high-
pressure cleaner. The temperature of the water should not be above 60 °C.
Keep the jet of water in constant movement during the washing process. Do
not direct the water jet at clearances, built-in electrical parts, plugs, seals, ven-
tilation grills or skylights. The vehicle may be damaged or water may enter the
interior.
12.1.2 Washing the vehicle
 Wash the vehicle only on a washing site intended for this purpose.
Avoid full sunshine. Observe environmental measures.
 Clean external applications and synthetic parts only with plenty of warm
water, suitable cleaning agents and soft cloth.
 Wash down the vehicle with plenty of water, a clean sponge or a soft brush.
In the case of stubborn dirt add dish washing liquid to the water.
 Treat rubber seals of doors and storage flaps with talc.
 Treat locking cylinder of doors and storage flaps with graphite dust.
12.2 Interior care
 Do not clean the tyres with a high-pressure cleaner. The tyres might be
damaged.
 Do not spray external applications (deco-films) directly with the high-pres-
sure cleaner. The external applications could come off.
 Never have the vehicle cleaned in a car wash. Water can penetrate in the
forced ventilations. The vehicle could be damaged.
 Treat stains immediately if possible.
 Synthetic parts in the living area are very delicate and should be treated
with care. Do not use solvents, alcohol-containing cleaning agents or scou-
rers containing sand. This procedure will help you to avoid brittleness and
formation of cracks.
 Do not pour any corrosive agents into the drain holes. Never pour boiling
water directly into the drain holes. Corrosive agents and boiling water
cause damage to drainage pipes and siphon traps.
 Do not use vinegar based products to clean the water system, or for decal-
cification of the water system. Vinegar-based products may cause damage
to seals or parts of the installation. Use standard decalcifying products for
decalcification.
 Save water. Mop up all remaining water.