STEP 2 Slide Mailbox Post Sleeve over 4x4
treated pine post. Make sure the mounting arm
is pointing toward the street.
STEP 5 Install Rear Door of Newspaper Port by
snapping pegs into the back indentations of the
Newspaper port. Installing the mailbox will create
a tight hold on the rear door.
STEP 3 Secure the Mailbox Post Sleeve
section to the 4x4 treated pine post using
the (4) #12 x 1" screws
C
included in the kit.
Screws will go through the plastic with slight
pressure. Do not over tighten.
STEP 6 Assemble your mailbox by using (2) pins
to attach Mailbox Door to holes in Mailbox Body.
Pins can be snapped into place by pressing rmly
with thumb or tapped in using a rubber mallet.
TIP: Make sure the pins are fully snapped into
place. If they are installed correctly, you will not
be able to remove the pins with your ngers.
TIP: Holes in door should be positioned outside
of holes on mailbox body before insertion of pins.
STEP 4 Snap Newspaper Port to top of Mailbox
Post Sleeve.
STEP 7 Place Mailbox on to top of Newspaper
Port, align holes of mailbox & newspaper port and
secure with (4) 24 x 1-1/2" Phillips Machine Bolts
A
and nuts
B
.
C
A
Postal Pro is a Creative Solutions, LLC Product
Manufactured in Purvis, MS
Customer Service 877-544-5220
customerservice@creativesolutionscp.com
www.postalpromailboxes.com
06/22
To Previous Page
Loading...