Potek BC0401 - Charging in Vehicle; Charging Removed Battery; Advanced Features & Data; LCD Display Guide

CHOOSE THE GROUND SYSTEM YOU WILL USE AND FOLLOW THE STEPS

CAUTION: 


Charging Modes
Failure Display
Votage or Failure Code Display




B. CHARGING BATTERY INSTALLED IN VEHICLE
C. CHARGING BATTERY REMOVED FROM VEHCILE
LCD Display Manual







 
 















Note: Connect and disconnect the DC output clamps ONLY AFTER removing the AC plug from the
electrical outlet. Never alow the DC output clamps to touch each other. This may cause a spark.
* Keep pressing the Mode buon for more than 3 seconds, you can change between and .




.


a
a
a






e
e
e