Potensic ATOM Series - Specifications

Introduction
The Potensic Atom series parallel charging HUB can charge three Atom intelligent batteries at the same time, and the
USB interface can be used for the remote control or other devices charge .
The box-like design makes it easy to carry and protect the battery.
Press the Battery Power Check Button, the indicator will light on to help you know the battery power before flying.
Charging
1. As Figure A, insert the battery and press it until you hear a "click", the battery is installed correctly. Then connect
the adapter with the charging HUB and plug in.
2. Users can insert 1-3 batteries at will, and the charging HUB will automatically identify the batteries and charge it.
When charging, the charging indicator lights of each battery keep flashing in sequence.
3. After fully charged, the corresponding indicator lights will be always-on. Remove the battery as shown in Figure B.
4. The USB interface can charge the remote control or other USB devices (5V/1A).
The charging HUB supports hot swapping of batteries without turning off the power.
After fully charged, it is recommended to wait for the red power indicator of the battery to go out before unplugging the
battery.
Check Battery Power
Specifications
Fault Reminder
After a battery is inserted or unplugged from the
charging butler, the corresponding battery indicator
will turn on.
Displays the battery level and turns off after 5
seconds. Or check by short pressing the button
Check the power.
When the battery is inserted, the corresponding
indicator light is shown in the figure, indicating that
there is a fault.
Abnormal battery temperature: Indicates that the
battery temperature has exceeded the safe charging
temperature range. The charging HUB will prevent
charging until the battery temperature returns to
normal.
Battery failure: It may caused by battery communica-
tion failure, battery cell failure, device short road.
0%~25%
25%~50%
50%~75%
75%~97%
97%~100%
LED 1 LED 2 LED 3 LED 4
Corresponding
Battery Power
Flickering
OffAlways-on
Abnormal battery
temperature
Battery failure
LED 1 LED 2 LED 3 LED 4
Fault Type
Flickering
OffAlways-on
Model
DSBC02A
Weight
About 137g(Without battery)
Working Temperature
5℃-40℃
Adaptable Battery DSBT02A (2500mAh) DSBT02B (2230mAh) DSBT02C (3450mAh)
Output 8V/2.2A * 3 8V/2.0A * 3 8V/1.6A * 3
5V/1AUSB Output
Charging Time ≈1.3 hours≈1.5 hours ≈2.6 hours
Adapter Specifications
Input: 100-240V, 50/60HZ Output: 12V/5A-60W
The charging HUB can charge 3 batteries at the same time, and supports mixed use of 3 adaptable
battery in the above table.
- 02 -