Pottery Barn Umbrella User Manual

9’ Round Market Umbrella
Assembly Instructions
Fig.1
Fig.4 Fig.6
Parts Included:
• (1) Umbrella (2 pieces – upper and lower)
• (1) Finial
• Canopy is not included
Assembly Instructions:
1. Attach the lower pole to the upper part of the umbrella (Fig.1). Turn the pole clockwise until the threads are
fully secure.
2. Note: The oval slot on the pole connector should align with the nut inside the upper pole. If they do not align
after tightening, loosen the lower pole by a half turn until they are aligned. Insert the wing nut into the hole in
the pole. Turn the wing nut clockwise until secure. (Fig.2)
3. Attach the finial to top of umbrella, turning it clockwise until secure. (Fig.3)
4. Set the umbrella into the umbrella stand. To prevent the umbrella from spinning, align the metal plate on the
bottom of the pole with the tightening knob on the umbrella stand.
5. To open the umbrella, pull the pulley rope until the hub mechanism is past the holes located at the top of the
umbrella pole. While holding the rope taut, insert the metal pin into the hole. (Fig.4)
6. Assembly is complete. (Fig.5)
7. To tilt, press the button and slowly tilt until you hear a click, then release the button. (Fig.6)
Care Instructions:
• Brush to remove dirt and dust.
• Canopy is removable: spot clean with water and mild soap; air dry.
Storage:
• Store in a dry, covered area when not in use.
• To prevent mildew, be sure the umbrella fabric is completely dry before storing. Store indoor when not in use
or during periods of inclement weather.
Wood:
• Do not use oil. For maintaining the finish, wash using a mild soap or cleaner to remove accumulated dirt.
• Cover during storage or when not in use, using a proper outdoor cover allowing adequate ventilation without
trapping moisture.
• Do not cover with plastic or similar materials that will trap moisture. Pottery Barn umbrella covers are vented
and can be used.
Thank you for your purchase
Stores l Catalog l www.potterybarn.com

Pottery Barn Umbrella Specifications

General

Brand	Pottery Barn
Model	Umbrella
Category	Safety Equipment
Language	English

Summary

Assembly Instructions

Attach Lower Pole

Connect the lower pole to the upper umbrella part by turning clockwise until secure.

Align Pole Connector and Insert Wing Nut

Ensure the oval slot aligns with the nut. Loosen/tighten pole for alignment, then secure wing nut.

Attach Finial

Secure the finial to the top of the umbrella by turning it clockwise.

Set Umbrella in Stand

Place umbrella in stand, aligning metal plate with tightening knob to prevent spinning.

Open Umbrella and Insert Pin

Pull rope until hub passes holes, then insert metal pin into the hole to secure.

Assembly Complete

Confirms that the assembly process is finished.

Tilting Mechanism

Press the button and tilt slowly until a click is heard, then release the button.

Care Instructions

Basic Cleaning

Use a brush to remove loose dirt and dust from the umbrella.

Canopy Cleaning

The canopy can be spot cleaned with mild soap and water, then air dried.

Storage Guidelines

General Storage

Keep the umbrella in a dry, covered location when it is not being used.

Mildew Prevention

Ensure fabric is dry before storing to prevent mildew; store indoors during bad weather.

Wood Care

Finish Maintenance

Avoid oil; use mild soap or cleaner for dirt removal to maintain the finish.

Protective Covering

Use a vented outdoor cover during storage or non-use to allow ventilation and prevent moisture.

Material Warning

Avoid plastic covers; Pottery Barn's vented covers are recommended for moisture management.