Poulan Pro PR20H42STC User Manual (English)

Questions and Answers:

M
matthew82Aug 1, 2025
How to fix uneven cut with Poulan Pro PR20H42STC?
- M
  Mark BensonAug 1, 2025
  An uneven cut with your Poulan Pro Lawn Mower can be due to several reasons: * A worn, bent, or loose blade: Replace the blade and tighten the blade bolt. * The mower deck not being level: Level the mower deck. * Buildup of grass, leaves, and trash under the mower: Clean the underside of the mower housing. * A bent blade mandrel: Replace the blade mandrel. * Clogged mower deck vent holes: Clean around mandrels to open vent holes.
M
michelle01Aug 6, 2025
What to do if Poulan Pro Lawn Mower blades will not rotate?
- J
  jasonrichardsAug 6, 2025
  If the blades on your Poulan Pro Lawn Mower won't rotate, consider these potential causes: * Obstruction in the clutch mechanism: Remove any obstruction. * Worn or damaged mower drive belt: Replace the mower drive belt. * Frozen idler pulley: Replace the idler pulley. * Frozen blade mandrel: Replace the blade mandrel.
N
njonesAug 11, 2025
Why Poulan Pro Lawn Mower battery will not charge?
- K
  Kevin GrahamAug 11, 2025
  If your Poulan Pro Lawn Mower battery isn't charging, it could be due to: * Bad battery cell(s): Replace the battery. * Poor cable connections: Check and clean all connections. * Faulty regulator (if equipped): Replace the regulator. * Faulty alternator: Replace the alternator.
Q
qlevyAug 15, 2025
Why Poulan Pro PR20H42STC headlight(s) not working?
- P
  prestonmichaelaAug 15, 2025
  If the headlights on your Poulan Pro Lawn Mower are not working, check the following: * Ensure the switch is "ON". * Bulb(s) burned out: Replace the bulb(s). * Faulty light switch: Check or replace the light switch. * Loose or damaged wiring: Check the wiring and connections. * Blown fuse: Replace the fuse.
J
James MooreAug 19, 2025
Why Poulan Pro PR20H42STC Lawn Mower has loss of drive?
- L
  Laura BushAug 19, 2025
  Loss of drive in your Poulan Pro Lawn Mower can occur due to: * Freewheel control in "disengaged" position: Place the freewheel control in the "engaged" position. * Motion drive belt worn, damaged, or broken: Replace the motion drive belt. * Air trapped in transmission during shipment or servicing: Purge the transmission.
J
James JordanAug 23, 2025
Why does Poulan Pro PR20H42STC Lawn Mower engine backfire when turning it off?
- C
  Calvin MartinezAug 25, 2025
  If your Poulan Pro Lawn Mower engine backfires when turning it off, it might be because the engine throttle control was not set at the "SLOW" position for 30 seconds before stopping the engine. Move the throttle control to the "SLOW" position and allow it to idle for 30 seconds before stopping the engine.

Poulan Pro PR20H42STC Specifications

General

Engine Type	Gasoline
Engine Power	20 HP
Engine	Briggs & Stratton
Engine Displacement	540 cc
Cutting Width	42 inches
Transmission	Automatic
Deck Material	Steel
Cutting Height	1.5 - 4 inches
Cutting Height Positions	6
Drive System	Rear-Wheel Drive
Speed Range	0-5.5 mph
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Weight	500 lbs
Wheel Size	15 inches (front), 20 inches (rear)