POURSTEADY
©2019 — REV 4.0
2
INSTALLATION
Poition Wi-Fi adaptr or plu-in
thrnt abl
onnt pump ontrol ir
Turn on Maro U boilr
Plu in and tt th Pourtad
2
• If using the WI-Fi adapter, locate it so that it
is out of the way of other plumbing and electrical
appliances and within range of the Wi-Fi signal.
• If you are using Ethernet, the Wi-Fi adapter does
not need to be installed. Bring the cable through
the hole and plug into the Ethernet jack located on
the machine.
• Plug the connector on the loose end of the pump
control wire into matching female connector on the
top of the Marco UC Boiler.
• Plug-in water heater and set temperature following
Marco’s instructions.
• Wait for it to indicate that it is ready.
NOTE: There is typically a 6-8ºF (3-5ºC) drop from
the heater to the nozzle. We recommend 206ºF (96ºC)
on the Marco for 200ºF (90ºC) water at the nozzle.
• Plug the power supply into the 110V outlet. This
will power up the Poursteady.
• Wait until the lights around the buttons ash a
few times and the mechanism goes through its homing
routine. (about 1 minute)
• Test the machine by making a cup of coffee (refer
to page 19)
• Replace the side cover, top cap, and the screws
holding them in place.
• You should be ready to go!
To Next Page
Loading...