Poursteady PS1-3c - Page 9

POURSTEADY
©2019 — REV 4.0

INSTALLATION
1.75in
(45mm)
Intall Maro U Boilr
Poition Pourtad
2
3
• Position the hot-water heater directly below, or as
close as possible to the hole in your counter-top.
• Follow all installation instructions provided with
the hot-water heater—including water and power
requirements.
• Note: Water quality will affect the lifetime
performance of both the boiler and the Poursteady
brewer.
• Move the Poursteady so that the left-side of the
operator’s side of the machine (facing the buttons)
is over the hole.
• Remove the left-hand cover by removing the 2 screws
on the top of the machine, and then the 8-screws
along the sides. Carefully slide the panel up.
(Tip: to keep the electronics covered, you can
slide the panel up a few inches and secure it in
place temporarily with one of the screws.)
DO NOT TURN ON BOILER
!
ut hol in ountr-top
• Locate the Poursteady PS1/PS1-3c with the buttons
facing the operator in the desired location. Place
a temporary mark for reference.
• Cut a 1.5” × 3" (38mm × 76mm) slot in the counter as
shown below:

OPERATOR’S SIDE