You are now presented with the primary screen
Top left – when first switched on, the distance that
the trolley has covered since new will be displayed.
This cannot be reset. When the trolley motor starts,
the display will automatically zero and count the
yards/metres for that round. When the battery has
been disconnected, the total for that round is added
to the grand total.
MPH/KPH
indicates the
approximate speed of travel
in the chosen mode
Bottom left –
Yards/metres indicates the
total distance travelled for
the current shot. This can be
returned to zero by holding
+ arrows together.
Central large number indicates
the speed selected. This is
adjusted from ’0’–’9’ by
pressing the appropriate
and arrow. The
display will flash when
the machine is stopped.
When you press the
display will stop flashing
and power will be applied
to the motor at the
requested speed, then the
machine will move off.
Top right – the clock can be set as explained
later in ‘Programming Mode’ screen.
Side right – the battery indicator gives an
indication of the battery condition. When fully
charged, 5 bars will be shown and a full 18 hole
round can be expected, or 36 holes if using a 36
hole battery. It is normal for the display bars to
reduce through the round. Please note that the
lithium battery is designed for 18 hole use.
52.9 05:49
MILES
YDS
MPH
0.0
000
Your screen will now turn white as a clear
indication that you are in competition mode and
you will not have any measurements shown on
the screen except actual speed of travel.
The speed setting and the time will still be
displayed in the normal way.
Although the total distance covered is not
shown, it will be added to the total distance
covered recorded in the trolley memory.
DISTANCE MEASURE
GB
NOTE – as a power saving feature, if no button is pressed for 5 minutes,
the screen will power down. Touch any button and the screen will return to view.
WHEEL DISCLAIMER
Li
Competition Mode
Your FWII is equipped to comply with competition
rules in all countries and the distance function can
be disabled.
To put your FWII into competition mode, start with
the battery unplugged and then attach it.
Press the for at least 3 seconds until the FWII
logo appears.
The first screen will be displayed with the FWII
logo and you will be offered ’
√
’ + ’X’.
Highlight the ’X’ using the and arrows and
then press .
Your new FWII is fitted with a Digital Distance
Function (DDF).
This will allow your machine to proceed ahead of
you for a pre-determined distance and then stop.
Hold down the button for 4 seconds and the
DDF screen will be displayed, offering you a choice
of 10, 20 or 30 yards/metres approximately.
Select your chosen distance using the and
arrows and then select using the button.
Your machine will then move off and stop after the selected distance has been covered.
Ensure that the route is flat, safe and clear.
0001
0.0
000
05:49
Y
YDS
10
Y
30
Y
MPH
20
Y
If alternative wheels are used this will affect the speed and distance readings.
DDF will not function when the machine is in
competition mode.
Pb
Freeway2 instructions 10 ver8.qxp 30/1/09 18:17 Page 6
To Next Page
Loading...
Need help?
General
