MODEL NO. 941-138
938-138
ASSEMBLY INSTRUCTIONS (ZMS)
Made in China
Thank you for purchasing this Powell product. We want to make sure it is complete and to your satisfaction. Please check
all packing material carefully for small parts which may have come loose inside the carton during shipment. Hardware
can be identified by bright red packaging, Separate, identify, and count all parts and hardware to make sure they m
atch
with the illustrations herein and are all present. If any part(s) are missing or defective please contact Powell Customer
Service. Contact information is given at the bottom of these instructions. If you feel the item is defective beyond a
resolution with part replacements, please return this product with your receipt to the place of purchase. If purchased
from
an internet retailer, please contact their customer service department. Photo’s and additional information may be
requested to validate the claim. Product is not to be returned to the Powell Company under any circumstance unles
s
authorized by the Powell Company or an authorized dealer or representative. Thank you.
ATTENTION: SOME LETTERED PARTS LISTED ON THE INSTRUCTION SHEET MAY NOT BE IN PARTS BAG AS THEY MAY ALREADY
BE ASSEMBLED. CAREFULLY CHECK PARTS AND PACKING MATERIALS PRIOR TO ORDERING REPLACEMENTS.
WARNING: DO NOT FULLY TIGHTEN SCREWS AND BOLTS UNTIL ALL PARTS HAVE BEEN ASSEMBLED PROPERLY.
TO PREVENT SCRATCHING THE TOP SURFACE, ASSEMBLE PRODUCT ON A SMOOTH SURFACE.
DO NOT OVER TIGHTEN SCREWS AND BOLTS.
Tools Required for assembly: Allen Wrench (included)
PEWTER
BLACK
Replacement parts, including additional guardrails,
may be obtained from Powell Company.
This bed is designed to use only a mattress which is
74"- 75" long and 37-1/2” - 38-1/2" wide
Ensure thickness of mattress does not
exceed 8"
and surface of mattress thickness is does not less
than 5"
To Next Page
Need help?
General
