Power Climber Wind IBEX 1000 series User Manual

WARNING:
OPERATORS
MANUAL
IBEX
®
1000 Series
The IBEX
®
1000 Climb Assist System is NOT a safety device and must only be used when
user is connected to independent fall arrest system.
All personnel operating this equipment must read and completely understand this manual.
All personnel must be thoroughly trained in the use of the equipment and its operational and
safety features.
Only authorized and physically t personnel shall operate the equipment.
All persons operating this equipment must wear a safety harness at all times and tie-off as
required.
Any operation in violation of these instructions is at the operator’s own risk and may result
in serious injury.
Only use spare parts supplied by Power Climber Wind.
Climb Assist System
(Models 1050, 1065, 1080, & 1100)

Power Climber Wind IBEX 1000 series Specifications

General

Resistance Type	Magnetic
Drive System	Front Drive
Display	LCD
Programs	12
Type	Elliptical

Summary

Operators Manual Overview

General Safety Warnings

Critical safety instructions for operating the IBEX® 1000 Climb Assist System, emphasizing it's not a safety device and requires user training.

Equipment Description and Specifications

General Description and Components

Safety Precautions

Highlights caution for pacemakers and reiterates that the IBEX is not a safety device.

Assembly and Installation

Standard Components List

Installation Guidelines and Precautions

Provides notes on installation complexity, technician requirements, and PPE usage during installation.

Bottom Assembly Installation

Mounting Position and Rung Supports

Instructions for choosing the mounting position and installing rung supports for the bottom assembly.

Motor Assembly Installation Tip

Upper Assembly Installation

Component Unpacking and Mounting

Rung Supports and Sheave Assembly Mounting

Roller and U-Bolt Installation Tip

Belt Path Management

Pull-In Belt Roller Installation

Belt Path Routing Warning

Electrical Components

Electrical Control Box and Antenna Installation

Control Box Mounting and Wiring

Power Cord Routing and Safety

Guidelines for routing the AC power cord, securing it, and avoiding hazards, requiring turbine owner approval.

EasyClimb Controller and Commissioning

EasyClimb Controller Operation

System Commissioning Steps

Detailed steps for commissioning the IBEX® 1000 system, including controller checks and installation verification.

Operation Instructions

Setting Assistance Levels

How to set the desired level of assistance for ascent and descent using the STOP, UP, and DOWN buttons.

Ascending the Ladder

Steps for connecting the controller, initiating ascent, and stopping safely.

Ascent Safety Notes

Notes on ensuring safe operation, setting levels during motor operation, and stopping at the top.

Operating Procedures and Safety

Descending and Stopping

Instructions for descending, stopping the system, shutting it down, and handling momentary stops.

Operational Notes and Safety Considerations

Miscellaneous operational points, delays, controller orientation, and safety regarding multiple controllers.

Maintenance and Troubleshooting

Periodic Belt Inspection

Procedure for regularly inspecting the assist belt for wear, damage, or weld separation.

Troubleshooting Common Issues

Table listing common symptoms like belt slippage or controller issues and their potential causes and solutions.

Component Replacement

Service and Warranty