2.5HP AIR
COMPRESSOR
WITH 6 PIECE KIT PLUS AIR BRUSH KIT
Ver. 061110
BEFORE OPERATING THIS
APPLIANCE PLEASE READ
THESE INSTRUCTIONS
CAREFULLY
WARNING
QUICK REFERENCE GUIDE
1. Remove
plastic bung
from air intake.
PRIOR TO USING YOUR COMPRESSOR, PLEASE STUDY THESE
SUMMARY ASSEMBLY INSTRUCTIONS.
2. Screw air
intake filter into
where bung
removed.
3. Remove oil
filler travel bung
from top of
sump.
4. Top up sump
so oil level is
level with red
spot. Do not
overfill. Refer
to manual for
correct oil grade.
5. After topping
up with oil fit
sump breather
plug.
6. Push axle bolt
through wheel.
Ensure the long
wheel stem is
towards the
wheel mounting
bracket.
7. Fit plain
washer over
threads.
8. Push wheel
and axle onto
wheel bracket.
9. Fit plain
washer, spring
washer and nut.
Then tighten
with two
spanners.
10. Push rubber
foot into socket.
11. To fit the air hose into
the quick release coupling,
grip the hose firmly and
push the fitting into the
quick fit coupler on the
air compressor.
SAFETY TIP
To remove the hose, remember that this is
under pressure so stand to the side. Hold
the hose firmly with one hand and slide the
collar of the coupler in the direction of the
pressure switch to disconnect. You will hear a
gush of air as the hose disconnects.
To Next Page
Need help?
General
