5
Channel adjustment
1. The “CHANNEL SELECT” icon is used to adjust the transmitter frequency channel.
2. In the main menu, press the “SET” button to the “CHANNEL SELECT” icon.
3. When the “CHANNEL SELECT” icon is displayed, press the “UP” button to increase the channel number or “DOWN”
button to decrease the channel number. When the “UP”/“DOWN” button is pressed longer time, the channel number
will be increased / decreased in a fast manner until the button is released.
4. Once the desired frequency channel is reached, press the “SET” button to save and go to the next menu, if have no
any operation in 5 seconds, the receiver will exit to the main status. If press the “POWER” button to exit to the main
status without saving.
Audio Mode adjustment
1. The “MODE SELECT” icon is used to adjust the transmitter audio inputs mode.
2. In the main menu, press the “SET” button to the “MODE SELECT” icon.
3. When the “MODE SELECT” icon is displayed, press the “UP” button to select “STEREO” mode and “DOWN” button to
select “MONO” mode.
4. Once the desired frequency group is reached, press the “SET” button to save and go to the next menu, if have no any
operation in 5 seconds, the receiver will exit to the main status. If press the “POWER” button to exit to the main status
without save.
Power Mode Adjustment
1. The “POWER SELECT” icon is used to adjust the transmitter radiated power.
2. In the main menu, press the “SET” button to the “POWER SELECT” icon.
3. When the “POWER SELECT” icon is displayed, press the “UP” button to select “H” mode for higher radiant power and
“DOWN” button to select “L” mode for lower radiant power.
4. Once the desired frequency group is reached, press the “SET” button to save and go to the next menu, if have no any
operation in 5 seconds, the receiver will exit to the main status. If press the “POWER” button to exit to the main status
without save.
Lock Adjustment
1. The “LOCK SELECT” icon is used to lock all the transmitter settings.
2. In the main menu, press the “SET” button to the “LOCK SELECT” icon.
3. When the “LOCK SELECT” icon is displayed, press the “UP” button to select “LOCK OFF” mode and “DOWN” button to
select “LOCK ON” mode.
4. Once the desired frequency group is reached, press the “SET” button to save and go to the next menu, if have no any
operation in 5 seconds, the receiver will exit to the main status. If press the “POWER” button to exit to the main status
without save.
INSERT BATTERIES IN THE RECEIVER
Insert two 1.5V AA batteries to control the receiver. Open the receiver's front cover and insert the batteries as shown in the
battery compartment. The display shows the capacity of the batteries: When the battery indicator flashes, the batteries are
empty and the receiver will automatically switch off shortly after. If the receiver is not used for a long period (approx. 1-2 weeks),
remove the batteries to protect the device from possible leakage.
To Next Page
Loading...