4
DISPLAY
1. Left / Right AF signal icon
2. Frequency
This six-character display is used to show the
frequency menu.
3. Group Display
Display the selected frequency group for the
PD800 transmitter.
4. Channel Display
Display the selected frequency channel for the
PD800 transmitter.
5. Audio mode
Display of Mono or Stereo audio mode.
6. Lock icon
The lock icon indicates whether mode is on or
off. When the lock function is enabled, the PD800 transmitter is locked in the menu.
7. Power mode
8. Menu icons
The menu icons include the following functions: group select, channel select, mode select, power select, lock select
and exit setup.
RECEIVER
1. LED Indicator
2. LCD display
3. Infrared signal window
4. Up / Down button
5. Set / Sync button
6. Battery compartment (2xAA batteries)
7. Battery compartment cover
8. Lock button / Release button
9. Antenna
10. Earphone jack
11. Belt clip
12. On/Off switch and volume control
13. Rf signal icon
14. Audio mode
15. Lock icon
The “Lock” icon is used to indicate that the lock function
is enabled (Lock Icon light on) or disabled (Lock Icon light
off). When the lock function is enabled, the PD800
receiver is locked the menu operations.
16. Battery-level meter
This is used to indicate the battery power level. When the
battery power level is below a predetermined level, this
battery level meter will start to blink and the batteries
need to be replaced immediately.
17. Group display
This display is used to show the current frequency group setting.
18. Channel display
This display is used to show the current frequency channel setting.
19. Frequency
This six-character display is used to show the frequency or to show lock menu.
Group adjustment
1. The “GROUP SELECT” icon is used to adjust the transmitter frequency group.
2. In the main menu, press the “SET” button to the “GROUP SELECT” icon.
3. When the “GROUP SELECT” icon is displayed, press the “UP” button to increase the group number or “DOWN” button
to decrease the group number. When the “UP”/“DOWN” button is pressed steadily, the group number will be increased
/ decreased in a fast manner until the button is released.
4. Once the desired frequency group is reached, press the “SET” button to save and go to the next menu, if have to any
operation in 5 seconds, the receiver will exit to the main status. If press the “POWER” button to exit
5. to the main status without save.
To Next Page
Loading...