Power Fist 8558215 - User Manual

Questions and Answers

J
Johnny FisherAug 9, 2025
What to do if my Power Fist Nail Gun skips driving fasteners?
- R
  Robert MontgomeryAug 10, 2025
  If your Power Fist Nail Gun is skipping fasteners, several factors could be at play. It might be due to a worn bumper, dirt in the nose piece or magazine, a damaged pusher spring, or inadequate airflow. Try these steps: * Replace the bumper. * Clean the drive channel and magazine. * Replace the spring. * Check the fitting, hose, and compressor for airflow issues. Also, check for worn O-rings on the piston or trigger valve. Replace and lubricate O-rings as needed. Tighten any loose screws and fittings. If the cap seal is leaking, replace the gasket.
B
Bryan MillerAug 15, 2025
Why are fasteners jammed in my Power Fist 8558215?
- J
  Jeremy BauerAug 15, 2025
  If fasteners are jammed in your Power Fist Nail Gun, it could be due to a worn guide on the driver, incorrect fastener size, bent fasteners, loose screws, or a damaged driver. Here’s what you can do: * Replace the worn guide on the driver. * Ensure you are using the recommended fastener size. * Replace any bent fasteners with undamaged ones. * Tighten any loose magazine or nose screws. * Replace the driver if it is damaged.
K
Kathy RomeroAug 20, 2025
How to fix air leaking between housing and nose on Power Fist Nail Gun?
- G
  gabrielnicholsonAug 20, 2025
  If you notice air leaking between the housing and nose of your Power Fist Nail Gun, it could be due to loose screws, damaged O-rings, or a damaged bumper. Try tightening the screws first. If the leak persists, replace the damaged O-rings or the bumper.
E
Elaine SmithAug 25, 2025
Why does my Power Fist Nail Gun run slow or lose power?
- G
  Gina NguyenAug 26, 2025
  If your Power Fist Nail Gun is running slowly or has lost power, it might not be sufficiently lubricated, or there could be a broken spring in the cylinder cap, or a blocked exhaust port. Try lubricating the nailer first. If that doesn't solve the issue, consider replacing the spring or other damaged internal parts.
C
Carlos JohnsonAug 30, 2025
What to do if Power Fist 8558215 Nail Gun leaks air between housing and cap?
- H
  Holly GarrisonAug 30, 2025
  If air is leaking between the housing and cap of your Power Fist Nail Gun, it's likely due to loose screws or a damaged gasket. First, try tightening the screws. If the leak continues, replace the damaged gasket.
J
Joe SmithSep 3, 2025
How to fix air leaking at the trigger valve area of Power Fist Nail Gun?
- M
  Michele MarshallSep 3, 2025
  If your Power Fist Nail Gun is leaking air at the trigger valve area, the O-rings in the trigger valve housing may be damaged. Replace the O-rings and check the operation of the Work Contact Element (WCE).