Why is my Power Fist HVLP producing an uneven spray pattern?
An uneven spray pattern may occur if material has built up on the fluid nozzle tip/center hole, partially clogging the nozzle orifice, or if the fluid nozzle is loose. Try cleaning the head and nozzle, ensuring precise centering between them, and checking the pin tip. If necessary, replace the head and nozzle.
What to do if the Power Fist HVLP Paint Sprayer spray pattern is intermittent?
If the spray pattern is intermittent, it could be due to air in the paint circuit or a scratched/plugged nozzle. Try these steps: * Tighten the nozzle using the provided wrench. * Check the fluid level in the container. * Ensure connector holes are clear. * Tighten all fittings around the paint circuit. If the nozzle is damaged, clean it or replace it.
What to do if Power Fist HVLP has little to no paint output?
If there's little to no paint output, it might be because the fluid passage is clogged or the air holes in the cover are blocked, or the fluid needle stroke is too small. Remove any obstructions and adjust the fluid needle stroke.
Why is the spray concentrated in the center with my Power Fist HVLP Paint Sprayer?
Poor atomization with the spray concentrated in the center happens when the flow of paint is greater than the pressure and quantity of air supplied, or the paint viscosity is too high. Clean the head and the nozzle. Also, make sure that the paint is not too dense; dilute if necessary.
How to fix arched spray pattern on Power Fist HVLP Paint Sprayer?
An arched spray pattern can occur if material residue in the holes obstructs the passage of material, the nozzle is dirty or malfunctioning, or the atomization cap is dirty or damaged. Submerge the head in solvent. Clean and open all closed holes with compressed air or a toothpick, avoiding pointed metal objects.
Why is the center of the spray pattern too narrow when using my Power Fist HVLP Paint Sprayer?
If the center of the spray pattern is too narrow, it could be because the atomization air pressure is too high or the working material is too thin. Reduce the quantity of air and increase the flow of paint. Alternatively, increase the paint viscosity.
General| Type | HVLP |
|---|---|
| Nozzle Size | 1.4 mm |
| Weight | 2.2 lbs |
| Material | Aluminum |
| Air Inlet Size | 1/4 inch |
To Next Page
