Power Gear 7228AC - User Manual

Questions and Answers

M
Michael GillespieAug 1, 2025
What to do if my Power Gear Tools system will not turn on?
- A
  Anthony CainAug 1, 2025
  If your Power Gear Tools system won't turn on and the indicator light is off, it could be due to several reasons. First, ensure the coach ignition is in the RUN position. Next, verify the transmission is in PARK or NEUTRAL. Also, make sure the parking brake is set. Finally, if the control has been left on for more than four minutes, the auto shut-off may have activated; push the ON/OFF button twice to resolve this.
R
Robert FuentesAug 7, 2025
Why won't one or two of my Power Gear 7228AC jacks retract?
- C
  coxjamesAug 7, 2025
  If your Power Gear Tools jacks will not retract at all, it might be due to a broken jack spring. In this case, consider replacing the jack spring. Alternatively, the jack rod guide might be rusted or dirty. Try cleaning the chrome rod and greasing the rod guide if it has grease fittings; otherwise, lubricate it with silicone fluid. Resealing or replacing the jack might also be necessary.
S
Sarah RodriguezAug 12, 2025
What to do if all my Power Gear Tools jacks will not retract fully?
- J
  janetkleinAug 12, 2025
  If all your Power Gear Tools jacks won't retract fully, it's possible that the system has been overfilled with fluid. To fix this, drain the fluid to the recommended level.
S
Scott BuchananAug 18, 2025
What to do if my Power Gear 7228AC Tools jacks will not extend and the pump is not running?
- R
  Rhonda LawrenceAug 18, 2025
  If your Power Gear Tools jacks will not extend and the pump isn't running, the battery voltage might be low. Try recharging the battery.
Z
zgonzalezAug 25, 2025
What to do if my Power Gear Tools jacks will not extend, but the pump is running?
- T
  Thomas MccoyAug 26, 2025
  If your Power Gear Tools jacks will not extend but the pump is running, the fluid level might be low. Refill the tank to the proper level using automatic transmission fluid.