Power Sentry PS1050DL FIK User Manual (English)

To Next Page

See appropriate Power Sentry Installation Instructions for applicable warnings and precautions

Power Sentry Field Install

Wiring Diagram & Instructions - Downlight

Field Install Instructions *

1. Disconnect Neutral from Driver

2. Connect Neutral to Power Sentry WHITE

3. Connect Power Sentry RED/WHT to Driver Neutral

4. Connect Line to Power Sentry UNSWITCHED BLACK (Line input must be un-switched)

5. Connect Power Sentry RED wire to wire nut with Driver LED (+) (in this example RED)

6. Remove Driver LED (-) wire from wire nut (in this example BLACK)

7. Connect Power Sentry YEL wire to wire nut with LED Board (-)

8. Connect Power Sentry BLU wire to wire nut with Driver Led (-) (in this example BLACK)

9. Cap unused BLU/WHT and YEL/BLK wires

*SEE REVERSE FOR MOUNTING OPTIONS AND PLACEMENT

Need help?

Do you have a question about the Power Sentry PS1050DL FIK and is the answer not in the manual?

Power Sentry PS1050DL FIK Specifications

General

Instruction to disconnect the neutral wire from the driver unit.

Connect the neutral wire to the WHITE terminal on the Power Sentry.

Connect the RED/WHT wire from Power Sentry to the driver's neutral.

Connect the line input to the UNSWITCHED BLACK wire of the Power Sentry.

Connect the Power Sentry RED wire to the driver's LED positive terminal.

Remove the driver's LED negative wire from its connection.

Connect the Power Sentry YEL wire to the LED board's negative terminal.

Connect the Power Sentry BLU wire to the driver's LED negative terminal.

Securely cap any unused BLU/WHT and YEL/BLK wires.