EasyManuals Logo

Power smart PSM2521PH User Manual

Power smart PSM2521PH
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
CAUTION: Never place any type of storage cover or tarp on the MOWER while it is still hot.
If the MOWER is being stored for extended periods of time (30 days or more), drain fuel tank and carburetor
bowl.
When storing the mower for extended periods of time:
1. Start the engine and run it until the tank, carburetor bowl and fuel line are completely empty and the engine
stalls.
2. Change the oil after each season.
3. Remove the spark plug. Use an oil-can to fill the cylinder with approx. 2 ml of oil. Slowly pull back the starter
handle, which will bathe the cylinder wall with oil. Screw the spark plug back in.
4. Clean the cooling fins of the cylinder and the housing.
5. Be sure to clean the entire equipment to protect the paint.
6. Store the equipment in a well-ventilated place.
NOTE: LIMITED WARRANTY does not cover fuel system damage or engine performance problems
resulting from neglected storage preparation.
TROUBLESHOOTING
Problem Cause Solution
Engine fails to start
Engine
start/stop
lever
disengaged.
Engage
engine
start/stop
lever.
Spark
plug
wire
disconnected.
Connect
spark
plug
wire.
Fuel
tank
empty
or
stale
fuel.
Fill
tank
with
clean,
fresh
gasoline.
Engine
not
primed.
Press
primer
bulb.
Faulty
spark
plug.
Clean,
adjust
gap,
or
replace.
Blocked
fuel
line.
Clean
fuel
line.
Engine
flooded.
Wait
a
few
minutes
to
restart,
do
not
prime.
Engine runs erratic.
Spark
plug
wire
loose.
Connect
and
tighten
spark
plug
wire.
Blocked fuel line or stale fuel.
Clean fuel line. Fill tank with clean, fresh
gasoline.
Drain
carburetor
bowl.
Water
or
dirt
in
fuel
system.
Drain
fuel
tank.
Refill
with
fresh
fuel.
Dirty
air
filter
Clean
or
replace
the
filter.
Engine overheats.
Engine
oil
level
low.
Fill
crankcase
with
proper
oil.
Air
flow
restricted.
Clean
area
around
and
on
top
of
engine.
Idles poorly.
Spark plug fouled, faulty, or gap too
wide.
Reset gap or replace spark plug.
Dirty
air
cleaner.
Clean
or
replace
the
filter.
Excessive vibration/noise
Blade
loose
or
unbalanced.
Tighten
and
balance
blade.
Bent/damaged
blade.
Replace
the
blade.
Mower will not mulch
grass.
Wet grass.
Do not mow when grass is wet, wait until dry to
cut.
Uneven cut.
Excessively high grass.
Mow once at a high cutting height, then mow
again at desired height or make a narrower cutting
path.
Dull blade. Sharpen or replace blade.
EXPLODED VIEW AND PARTS LIST

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Power smart PSM2521PH and is the answer not in the manual?

Power smart PSM2521PH Specifications

General IconGeneral
BrandPower smart
ModelPSM2521PH
CategoryLawn Mower
LanguageEnglish

Related product manuals