Why is my Power works Lawn Mower not starting?
Your Power works Lawn Mower might not be starting because the battery is low and needs charging, the battery is inoperable and needs replacing, or the battery key is not inserted. Try charging or replacing the battery, or inserting the battery key.
What to do if my Power works Lawn Mower motor stops while cutting?
If your Power works Lawn Mower motor stops while cutting, it could be due to the cutting height being set too low, or the battery having no power. Try raising the cutting height or charging the battery.
Why is my Power works Lawn Mower vibrating at a higher speed?
If your Power works Lawn Mower is vibrating at a higher speed, the blade might be unbalanced, excessively or unevenly worn, or the motor shaft may be bent. You should replace the blade. If the motor shaft is bent, stop the motor, remove the isolator key and battery, disconnect the power source, and inspect for damage. Have it repaired by an authorised service center before restarting.
Why is my Power works Lawn Mower hard to push?
Your Power works Lawn Mower might be hard to push because the grass is too high, the rear of the mower housing and blade are dragging in heavy grass, or the cutting height is set too low. Try raising the cutting height.
Install and remove the battery pack correctly.
Press safety button, pull power lever to start; release lever to stop.
Inspect product for damage, tighten fasteners, clean with cloths. Avoid solvents.
General| Brand | Power works |
|---|---|
| Model | 2500513 |
| Category | Lawn Mower |
| Language | English |
To Next Page
