15
DECLARATION OF CONFORMITY
Saxonar GmbH hereby declares that the power2max power meter complies with the essen-
tial requirements and further relevant provisions of the 1999/5/EC Directive. The complete
declaration of conformity is available at https://www.power2max.de
Statement of Compliance for FCC and lndustry Canada
This equipment has been tested and found to comply with the Iimits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These Iimits are designed to provide reasona-
ble protection against harmful interference in a residential Installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular Installation.
Operation is subject to the following two conditions: This device may not cause harmful
interference, and this device must accept any interference received, including interference
that may cause undesired operation. This product meets the applicable lndustry Canada
technical specifications. The term „IC:“ before the radio certification number only signifies
that lndustry Canada technical specifications were met.
WARNING:
Any changes or modifications not expressively approved by Saxonar GmbH could void the
user‘s authority to operate this equipment.
Statement of RoHS Compliance
Saxonar GmbH certifies that this product and its packaging are in compliance with Euro-
pean Union Directive 2002/195/EC on the Restriction of the Use of Certain Hazardous Sub-
stances in Electrical and Electronics Equipment, commonly known as RoHS.
Trademarks: power2max is a registered trademark of power2max GmbH. All other product,
trademarks and trade names mentioned in this user manual can be trademarks or brands
of the respective owner.
To Next Page
Loading...
Need help?
Battery
Transmission Standards
