27
Check the washer is still slightly domed to keep the pressure on
the bolt to stop it unwinding, keeping the blade firmly secure.
Then replace the washer (right way around!) and bolts.
Make sure the blade is correctly located, and then firmly tighten
the bolt. Use a torque wrench to tighten the blade bolt by
40 N∙m Do not over tighten. The up turn of the blade must
project into the motor compartment.
NOTE: If you are unsure about performing this operation, call
our helpline or go to an authorised dealer to change the blade
for you.
List of consumable parts:
QC12YC Spark plug 932217 Blade bolt
933918 Collection
grass bag
466018 Fixing knob
933206 Blade
Parts can be ordered via www.coreservice.co.uk.
To Next Page
Loading...
