24 25
Troubleshooting
Troubleshooting
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and
repair work must be performed by an authorised service
centre or a similarly qualified specialist if you cannot solve
the problem yourself!
Suspected malfunctions, disturbances or damages are often due to
causes that the user can resolve themselves; therefore, check the
product issues using this section. In most cases, the problem can
be solved quickly.
Fault Possible Cause Solution
Product does not
start
1. Not connected to
power supply
2. Power cord or
plug defective
3. Other electrical
defect to the
product
4. Lock-off button
not pressed
1. Connect to power
supply
2. Check by a
specialist electrician
3. Check by a
specialist electrician
4. Press lock-off
button first, then the
start/stop lever
Product does not
reach full power
1. Power source
(e.g. generator)
has too low
voltage
2. Air vents blocked
1. Connect to another
power source
2. Clean the air vents
Power result 1. Cutting device is
dull/damaged
2. Scarified material
exceeds capacity
3. Scarifying depth
is incorrect
1. Replace
2. Only scarify
materials according
to capacity of the
product
3. Adjust depth
Technical Data
Technical Data Table
Property Value
Model no. DT5310
Rated voltage 220-240V~50Hz
Power input power 1400W
No-load speed 5000/min
Max. cutting width 32cm
Working height setting 5 adjustments
(-10/-5/0/5/10mm)
Grass catcher bag 30L
Vibration 3.591m/s² K=1.5m/s²
Measured sound pressure level L
PA
84.5dB(A) K=3dB(A)
Measured sound power level L
wA
97.9dB(A) K=3dB(A)
Guaranteed sound power level L
wA
103dB(A)
Protection class
II /
Degree of protection IPX4
Machine weight 10.8KG
Cable length 10m
The sound intensity level for the operator may exceed 80 dB(A) and
ear protection measures are necessary.
The declared vibration value has been measured in accordance
with a standard test method and may be used for comparing one
product with another. The declared vibration value may also be used
in a preliminary assessment of exposure.
WARNING! Depending on the actual use of the product,
the vibration values can differ from the declared total!
Adopt proper measures to protect yourself against
vibration exposures! Take into consideration the whole
work process, including times the product is running
under no load or switched off. Proper measures include,
among others, regular maintenance and care of the
product and cutting attachments, keeping hands warm,
periodical breaks and proper planning of work processes!
To Next Page
Loading...