EasyManua.ls Logo

PowerBase DT5310 - Intended Use; Warnings Symbols

PowerBase DT5310
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 5
Training
Read the instructions carefully. Be familiar
with the controls and the correct use of the
equipment.
Keep in mind that the operator or user
is responsible for accidents or hazards
occurring to other people or their property.
Preparation
Wear ear protection and safety glasses
(PPE) at all times while operating the
machine.
Before use, check the supply and extension
cord for signs of damage or aging. If the cord
becomes damaged during use, disconnect
the cord from the supply immediately.
DO NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY. Do not use
the machine if the cord is damaged or worn.
While operating the machine always wear
substantial footwear and long trousers. Do
not operate the machine when barefoot or
wearing open-toed sandals. Avoid wearing
clothing that is loose fitting or that has
hanging cords or ties.
Thoroughly inspect the area where the
equipment is to be used and remove
all objects which can be thrown by the
machine.
Operate the machine in a recommended
position and only on a firm, level surface.
Do not operate the machine on a paved or
gravel surface where ejected material could
cause injury.
Before starting the machine, check that all
screws, nuts, bolts, and other fasteners are
well assembled.
Operation
Operate the machine only in daylight or in
good artificial light.
Avoid operating the machine in wet grass.
Always be sure of your footing at all times,
especially on slopes.
Walk, never run.
Mow across the face of slopes, never up and
down.
Exercise extreme caution when changing
direction on slopes.
Do not scarify or aerate excessively steep
slopes.
Use extreme caution when reversing or
pulling the machine towards you.
Stop the tines if the machine has to be tilted
for transportation when crossing surfaces
other than grass, and when transporting the
machine to and from the area to be worked
on.