PowerBlock POWERMAX STAND - Page 2

4
2
5
1
3
POWERBLOCK POWERMAX STAND ASSEMBLY
STEP TWO
TOOLS NEEDED: ONE 8 mm WRENCH.
1. ATTACH BOTH TOPS (ITEM 2) TO LEG ASSEMLBY (ITEM 1) WITH SUPPLIED HARDWARE.
TIGHTEN HARDWARE.
2. APPLY TRAY MATS (ITEM 4) TO TOPS (ITEM 2).
3. APPLY POWERBLOCK DECAL (ITEM 5) TO SPACER SUPPORT OF LEG ASSEMBLY.
TIGHTEN ALL HARDWARE.
FOR USE ON FIRM AND FLAT SURFACE ONLY.
ITEM NO. DESCRIPTION QTY.
1 POWERMAX STAND LEG ASSEMBLY 1
2 POWERMAX STAND TOP 2
3 M5 - 0.8 mm LOCK NUT 8
4 POWERMAX TRAY MAT 2
5 POWERBLOCK DECAL 1