Powerbuilt 640818 - Specifications

112
2 TON LOW PROFILE PROFESSIONAL SERVICE JACK
• STUDY, UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THIS DEVICE.
• DO NOT EXCEED RATED CAPACITY
• USE ONLY ON HARD LEVEL SURFACE
• LIFTING DEVICE ONLY. IMMEDIATELY AFTER LIFTING. SUPPORT THE VEHICLE WITH APPROPRIATE MEANS
• FAILURE TO HEED THESE MARKINGS MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE
• LIFT ONLY ON AREAS OF THE VEHICLE AS SPECIFIED BY THE VEHICLE MANUFACTURER
• NO ALTERATIONS SHALL BE MADE TO THIS PRODUCT
• ONLY ATTACHMENTS AND/OR ADAPTERS SUPPLIED BY THE MANUFACTURER SHALL BE USED
• DO NOT MOVE OR DOLLEY THE VEHICLE WHILE ON THE JACK
SPECIFICATIONS
Rated Capacity (Safe Working Load) 2 Ton (4000 LB) (1814 KG)
Weight 75.9 LB (34.4 KG)
Lowered Height 3-1/2" (9 cm)
Maximum Height 21-1/4" (54 cm)
Capacidad Calificada (Carga de trabajo segura) 2 Toneladas (4000 LB) (1814 KG)
Peso 75.9 LB (34.4 KG)
Altura baja 3-1/2" (9 cm)
Altura máxima 21-1/4" (54 cm)
WARNING
Ram (Not Shown)
Embolo (No se Demuestra)
Lift Arm Linkage
Unión del Brazo
Elevador
Front Wheel
Rueda Delantera
Rear Caster
Inclinación Posterior
Yo k e
Balancín
Handle Socket
Dado de la Manija
Handle Socket
Screw
Tornillo del Dado
de la Manija
Handle
Manija
Lift Arm
Brazo Elevador
Saddle
Asiento
No. Description Descripción Qty.
1 Front Wheel Axle Eje, Rueda Delantera 1
2 Front Wheel Rueda Delantera 1
3 Washer Arandela 2
4 Screws M12 Tornillos M12 2
5 Screws M8 Tornillos M8 2
6 Left Side Plate Placa Izquierda 1
7 Washer Arandela 4
8 Screws M12 Tornillos M12 4
9 Caster Assembly Unidad de Ruedecilla 2
10 Screws M8 Tornillos M8 4
11 Screws M6 Tornillos M6 4
12 Washer Arandela 2
13 Screws M18 Tornillos M18 2
14 Washer Arandela 2
15 Locking Nut Contratuerca 2
16 Returning Spring Muelle de Retorno 2
17 Ram Assembly Conjunto del Ariete 1
18 Block Link (ram) Eslabón de Bloqueo (ariete) 1
19 Cotter Pin Pasador de Chavetas 1
20 Roll Pin Pasador de Rodillo 1
21 Bolt Perno 1
22 Yoke Eje del Rodillo del Bombeador 1
23 Upper Handle Manija Superior 1
24 Bolt M6 Perno M6 1
25 Lower Handle Manija Inferior 1
26 Inspection Plate Placa de inspección 1
27 C-Ring Anillo en C 2
28 Bushing Buje 2
29 Strut Puntal de Suspensión 1
30 Shaft Arm Brazo del Mango 1
31 Right Side Plate Placa Derecha 1
32 Linkage Bolt Perno de Unión 2
33 Washer Arandela 1
34 Nut M12 Tuerca M12 2
35 Saddle Asiento 1
36 Saddle Center Bolt Perno Central del Soporte 1
37 Long Linkage Unión Larga 2
38 C-Ring Anillo en C 2
39 Saddle Platform Strut Arandela 12 1
PARTS LIST • LISTA DE PIEZAS