EasyManua.ls Logo

PowerCare AP31EW01 User Manual

PowerCare AP31EW01
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
36 in. EXTENSION WAND SYSTEM
AP31EW01
WARNING:
To reduce the risk of injury, user must read and understand the operator’s
manual for their pressure washer before using this accessory. To reduce the
risk of injury or property damage, spray the pressure stream in a safe direction
to ensure proper connection of all accessories before starting any cleaning
project. Fits most pressure washers. Ensure compatibility and proper fit before
using this accessory. Wear eye protection marked to comply with ANSI Z87.1.
Risk of fluid injections; do not point at people, pets, electrical devices or the
unit itself. Turn off the pressure washer, relieve the water pressure in the trig-
ger handle, and lock the lock out on the trigger handle (if one is included with
your pressure washer) before installing, changing, or adjusting accessories.
For cold water use only. For outdoor use only – store indoors. Save these
instructions. Refer to them frequently and use them to instruct other users. If
you loan someone this tool, loan them these instructions also.
This extension wand system is for use with pressure washers up to 4500 PSI.
INSTALLING/REMOVING THE EXTENSION WAND
See Figure 1.
n Place the threaded end of the extension wand (B) in the connector on the end
of your trigger handle (A). Turn the coupler clockwise until it stops to secure
the connector in place.
n Attach the quick connect coupler (C) into the extension wand (B) and check
to make sure it is secured properly.
n Place the threaded end of your spray wand (D) in the connector on the end
of the quick connect coupler (C). Turn the coupler clockwise until it stops to
secure your spray wand in place.
n Unscrew the extension wand from your trigger handle to remove.
Fig. 1
D
C
B
A
TECHTRONIC INDUSTRIES POWER EQUIPMENT
P.O. Box 1427, Anderson, SC 29622, USA n 1-866-340-3912
Manufactured for the Home Depot Corp., Atlanta, GA 30339 by Techtronic Industries Power Equipment
995000639
8-1-18 (REV:01)
Fits these brands / adapte ces marques / cabe estas marcas de fábrica:
BRUTE, BRIGGS & STRATTON, CAMPBELL HAUSFELD, CRAFTSMAN, DEWALT, EXCELL, HOMELITE, HUSKY, JOHN DEERE, KARCHER, MILWAUKEE, RIDGID,
RYOBI, TASK FORCE, TROY-BILT
The 36 in. wand can also be used to replace your existing spray wand and is
compatible with most 1/4 in. quick-connect accessories and nozzles.
The 36 in. wand can be used between your trigger handle and your existing spray wand to extend them.
Question and Answer IconNeed help?

Do you have a question about the PowerCare AP31EW01 and is the answer not in the manual?

PowerCare AP31EW01 Specifications

General IconGeneral
BrandPowerCare
ModelAP31EW01
CategoryPressure Washer
LanguageEnglish

Summary

General Safety Warnings

Extension Wand Installation and Removal

Connect Wand to Trigger Handle

Attach extension wand (B) to trigger handle (A) connector, turning clockwise.

Attach Quick Connect Coupler

Connect quick connect coupler (C) to extension wand (B) and ensure it's secured.

Connect Spray Wand to Coupler

Attach spray wand (D) to quick connect coupler (C) connector, turning clockwise.

Remove Extension Wand

Unscrew the extension wand from the trigger handle to remove it.