Powerfist 16-Speed Floor Mount Drill Press

Questions and Answers

W
Whitney MunozAug 4, 2025
What to do if my Powerfist 16-Speed Floor Mount Drill Press motor won't start?
- C
  Cynthia HowardAug 4, 2025
  If the Powerfist Power Tool's motor won't start, first ensure the power supply cord is properly connected and check the fuse. Then, inspect the motor and switch connections. A faulty switch or outlet could also be the culprit, so consider replacing them. Additionally, confirm the pulley cover is securely closed and that the micro switch on the cover is functioning correctly; renew or adjust it if necessary. In the worst case, the motor windings might be burned, requiring a motor replacement.
K
kristinpachecoAug 9, 2025
Why is my Powerfist 16-Speed Floor Mount Drill Press making a noisy operation under load?
- K
  Kayla ChungAug 9, 2025
  If your Powerfist Power Tool is noisy when under load, it could be due to several reasons. Start by checking the belt tension and adjust if necessary. Another cause might be a dry spindle, in which case you should remove the spindle and quill assembly and lubricate it. Also, ensure the pulley is tightened. A worn bearing can also cause noise, so consider replacing it.
W
Wendy SanchezAug 13, 2025
What to do if Powerfist 16-Speed Floor Mount Drill Press drill binds in workpiece?
- C
  Christine SmithAug 13, 2025
  If the drill binds in the workpiece when using your Powerfist Power Tool, it could be due to excessive feed pressure; try applying less pressure. Also, check the belt tension, and make sure the drill is tightened with the key. Ensure that the drill speed is appropriate for the material. If the drill angles are incorrect for the material, consult a technical manual and sharpen the drill accordingly.
R
Ryan PowersAug 18, 2025
How to fix excessive drill wobble on Powerfist 16-Speed Floor Mount Drill Press?
- C
  Christopher MartinezAug 19, 2025
  Excessive drill wobble in your Powerfist Power Tool can be caused by several factors. First, check if the chuck is loose and tighten it by pressing it down on a block of wood against the table. If the spindle or bearing is worn, replace the spindle shaft or bearing. A worn chuck may also cause wobble, so replace it if necessary. Finally, a bent drill bit will cause wobble, so renew the drill bit.
E
ericmasseyAug 23, 2025
Why does my Powerfist 16-Speed Floor Mount Drill Press drill bit burn or smoke?
- W
  William KennedyAug 23, 2025
  If the drill bit burns or smokes while using the Powerfist Power Tool, it may be due to incorrect speed; adjust the drill speed accordingly. Ensure that swarf is discharging by cleaning the drill. Check the sharpness and taper of the drill bit, as a dull drill or improper clearance for the material can cause burning. Using coolant while drilling may also help. Lastly, reduce excessive feed pressure.
X
xlawrenceAug 28, 2025
What to do if Powerfist 16-Speed Floor Mount Drill Press table is difficult to raise?
- L
  Lindsay GonzalezAug 29, 2025
  If the table is difficult to raise on your Powerfist Power Tool, it may need lubrication with light oil. Alternatively, the table lock might be tightened; loosen the clamp.