6 GB/CY
Safety advice / Operation
Safety advice
Keep all the safety advice and instruc-
tions in a safe place for future refer-
ence!
J
WARNING!
DANGER OF
LOSS OF LIFE AND ACCIDENT
TO INFANTS AND CHILDREN!
Never leave children unsupervised with the pack-
aging materials. Danger of suffocation. Keep
out of the reach of children. It is not a toy.
J Always keep the product out of reach of children.
Children often underestimate danger. Store the
device indoors in an enclosed, dry place where
it cannot be reached by children.
J Ensure that staples and nails cannot under any
circumstances strike people or animals. Failure
to observe this advice may lead to injury.
J Wear personal protective equipment and always
wear safety glasses. This also applies to people
who may be helping with the work by support-
ing or holding the workpiece.
m CAUTION! Do not support yourself with your
hands under any circumstances near or in front
the stapler gun or on the surface being tacked.
One slip may result in injury.
J Every time before you use the device, check
that it is in perfect condition. Damage to any of
its components may lead to injury.
J Check that all parts have been assembled and
fitted properly. Incorrect assembly or fitting
may lead to injury.
J Remain alert at all times and always watch what
you are doing. Proceed with caution. Just one
moment of inattention during assembly may
lead to injury.
J Before moving or putting away the stapler gun,
check that there are no staples or nails still in
the device.
Q
Operation
Q
Filling with staples / nails
m CAUTION! Use only the staples and nails
described in these operating instructions (see
“Staples / nails”). Failure to observe this advice
may result in damage to the device.
Note: You can use three different types of staples /
nails in the stapler gun; flat crown staples, round
crown staples and T-nails. All three types are sup-
plied with the stapler gun.
Follow these steps:
1. Press in the staple pusher
2
slightly and then
pull it downwards. Then pull the staple pusher
2
completely out of the magazine
4
(see Fig. A).
2. Push the staples or the T-nails into the maga-
zine
4
.
m CAUTION! Ensure that the staples or T-nails
are correctly inserted (see Figs. B, C, D).
3. Push the staple pusher
2
back into the maga-
zine
4
. Press in the staple pusher
2
slightly
and then pull it slightly upwards to fix it in place.
Q
Setting the impact force
m CAUTION! Never screw the adjusing screw
7
completely out of the stapler gun. This could
result in damage to the device.
j Screw out the adjusing screw
7
to reduce
the impact force.
j Screw in the adjusing screw
7
to increase
the impact force.
Q
Stapling
m CAUTION! Never support yourself by placing
your hands near or in front of the stapler gun
or the workpiece surface. A slip can result in
injury.
Follow these steps:
1. Press the staple eject opening
6
on the spot
where you wish to staple.
53466_Handtacker_Content_LB7.indd 6 17.05.10 15:17