LV710 Freight Camera - Dry Van Swing Door Installation
Revised: 05/23/19 28
25. Using router, create countersink feature around lens hole on the door interior.
i. Verify router has 5/16” rabbet bit installed.
j. Subtract 3/4” from overall door thickness. This is the depth of the countersink. Set the
router depth to this depth.
i. Example: If overall door thickness is 1”, set the router depth to ¼”
k. Slowly, move the router around the lens hole to create the countersink.
Create countersink with router
To Next Page
Loading...