PowerFleet LV710 - User Manual

LV710 Freight Camera - Dry Van Swing Door Installation
Revised: 05/23/19 1
Required Tools & Supplies:
Safety Glasses
Loctite Threadlocker Blue 242
Cordless Drill
with Battery
Phillips Screwdriver #2
Spring
-
loaded Punch
Sikaflex 252
Tape Measure
Caulk Gun
Permanent
Marker
#
25
Drill Bit (.
1495”
)
2 5/8” Hole Saw
Deburr Tool
¾” Hole Saw
External Caliper Gauge (digital)
12” Groove Lock Plier
3/16” Drill Bit
(countersink only)
Flat Blade Screwdriver
(countersink only)
Router (countersink only)
5/16” Rabbet
Router Bit (countersink only)
3 3/8” Hole Saw
(countersink only)
10
-
24 Tap
Cutting Oil
Installation Requirements:
1. Device must be installed on rear curbside door next to inner locking rod.
2. Overall door thickness must be ≤ 1.125”. Overall door thickness measurement must include any
interior and/or exterior sheathing in addition to the door core. Do not include any weather-
stripping around door edges in the thickness measurement.
a. Device will be installed by using Standard Installation procedure (pgs. 4-20) on doors with
thickness ≤ .75”.
b. Device will be installed by using Countersink Installation procedure (pgs. 21- 39) on doors
with thickness > .75” and ≤ 1.125”.
c. Doors with overall thickness > 1.125” cannot be installed.
Measure overall door thickness with external caliper

Summary

Device Activation

Record Device Information and Confirm Activation

Record MAC address and VIN, then confirm activation via LED flash.

Device Pairing

Contact Support and Provide Details for Pairing

Contact customer support with serial number and MAC address to pair devices.

Standard Installation Procedure

Pre-Installation Preparation

Confirm door thickness, assemble template, and mark installation points.

Exterior Hole Drilling

Drill the 2 5/8" lens hole and 3/4" positioning dowel hole on the exterior door.

Device and Magnet Mounting

Apply sealant, install shock mount hardware, mount device, and attach door trigger magnet.

Countersink Installation Procedure

Pre-Installation Preparation

Confirm door thickness, assemble template, and mark installation points.

Hole Drilling and Countersinking

Drill exterior, interior sheathing, and inner locking rod holes, and create countersink.

Device and Magnet Mounting

Apply sealant, install shock mount hardware, mount device, and attach door trigger magnet.

PowerFleet LV710 Specifications

General

Brand	PowerFleet
Model	LV710
Category	Digital Camera
Language	English