Assembly
To prepare your pressure washer for operation, you
will need to perform the following:
1. Attach handle to main unit
2. Attach axle / wheels
3. Add oil to engine
4. Add fuel to fuel tank
5. Connect high pressure hose to spray gun and
pump
6. Connect water supply to pump
7. Connect nozzle extension to spray gun
8. Select and install desired quick connect spray tip.
Attaching the Handle
1. Place handle assembly onto handle supports
connected to main unit. Ensure holes in handle
tube align with the locking pins in the frame and
the spring-loaded locking pins are engaged with
the handle.
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert multi-coloured spray tips in spaces provided
in handle.
B
A
CAUTION! Any attempt to crank or start the
engine before it has been properly filled with the
recommended oil will result in equipment failure.
Damage to equipment resulting from failure to follow
this instruction will void warranty.
Checking
the Engine Oil
IMPORTANT: All washers are shipped without engine
oil.
USE A QUALITY SAE30 GRADE OIL.
1. Place unit on a level surface
2. Remove oil filler cap / dipstick (A) and wipe it
clean.
3. Insert oil filler cap / dipstick into filler neck, but DO
NOT screw it in.
4. Remove dipstick. Proper oil level is at mid-point
of dipstick (A). Add oil if necessary to bring oil
level to top of threads (B). Oil capacity = 600ml.
5. Install and tighten cap.
NOTE: Check oil often during engine break-in.
!
POWERJET HIGH PRESSURE CLEANER
7.
To Next Page
Loading...