2
ü Keep flammable materials away from the generator/welder.
g The muffler becomes very hot during operation and remains hot for a while after stopping the
engine. Be careful not to touch the muffler while it is hot. Let the engine cool before storing the
generator/welder indoors.
g Gasoline is extremely flammable and is explosive under certain conditions. Do not smoke or allow
flames or sparks where the generator/welder is refueled or where gasoline is stored. Refuel in a
well-ventilated area with the engine stopped.
g Fuel vapors are extremely flammable and may ignite after the engine has started. Make sure that any
spilled fuel has been wiped up before starting the generator/welder.
gUse adequate eye protection. Eye protection is of the utmost importance, not only for the operator,
but also for any other personnel in the vicinity while welding is being done. Eye hazards include arc
glare, reflected glare, stray flashes, sparks, and flying bits of molten metal.
g Looking at a welding arc with unprotected eyes may produce severe pain and even temporary
blindness.
g Use a helmet or hand-held shield with a #10 or darker filter lens. Filter lenses eliminate the harmful
effects of infrared and ultraviolet radiation from the arc and reduce the glare from the arc light as
well.
g Wear protective clothing such as leather gloves, cap, sleeves, jacket, apron, and high-top safety
shoes. All outer clothing must be free of oil and grease.
To Next Page
