Powermate Coleman PW0872400.01 User Manual (English)

Questions and Answers:

R
Randy EdwardsJul 30, 2025
What to do if Powermate Coleman PW0872400.01 Pressure Washer pump is not building maximum pressure?
- P
  Patricia MitchellJul 30, 2025
  If your Powermate Pressure Washer isn't building maximum pressure or has irregular pressure, make sure the faucet is fully open. If the unit was stored in freezing temperatures, thaw it completely, including the hose, gun, and wand. Ensure you have a minimum water supply of 4 gpm at 20 psi. Also, check for and clean any clogs in the water inlet screen or kinks in the garden hose. Replace a worn or damaged wand nozzle. If there's air in the pump, let it run with the gun open and wand removed until a steady stream of water is released. Ensure the adjustable pressure knob is set to the maximum position.
K
Kimberly MccarthyAug 4, 2025
How to fix no intake of chemicals in Powermate Coleman PW0872400.01 Pressure Washer?
- C
  christylaneAug 4, 2025
  If your Powermate Pressure Washer is not intaking chemicals, ensure the injection tube is securely inserted into the unit. Replace the tubing if it's cracked or split. Use a low-pressure nozzle. Turn the injector collar counter-clockwise to turn it on. Clean the injection tube strainer if it's clogged. Also, make sure the nozzle is not blocked, and dissolve any dried chemicals in the injector by running warm water through the injection tube.
S
summer02Aug 9, 2025
What to do if Powermate Coleman PW0872400.01 Pressure Washer engine is overloaded?
- C
  Cynthia HarrellAug 9, 2025
  If the engine of your Powermate Pressure Washer is overloaded, it might be due to a partially blocked nozzle. Try cleaning the nozzle to resolve this. Alternatively, excessive pressure could be the cause; reduce the pressure by using the pressure adjustment knob.
Z
Zachary ThomasAug 14, 2025
Why Powermate Coleman PW0872400.01 Pressure Washer trigger will not move?
- A
  Angela ReynoldsAug 14, 2025
  If your Powermate Pressure Washer trigger will not move, it's likely that the gun safety lock is engaged. Simply release the safety lock to allow the trigger to move freely.
W
Wendy ArmstrongAug 19, 2025
How to lower high crankcase temperatures in Powermate Pressure Washer?
- E
  Eugene HarrisAug 19, 2025
  If you notice high crankcase temperatures in your Powermate Pressure Washer, it could be due to using the wrong grade of oil. Make sure you use the recommended oil. Also, check that the oil level in the crankcase is at the proper amount and adjust if necessary.
A
Anna HernandezAug 25, 2025
What causes rough operation with pressure drop in Powermate Coleman PW0872400.01 Pressure Washer?
- H
  Harold HamptonAug 25, 2025
  If you experience rough or pulsating operation with a pressure drop in your Powermate Pressure Washer, check the inlet lines for restrictions and proper sizing. Also, check the unloader for proper operation.