Powermate PFTT142 User Manual (English)

Questions and Answers:

C
Carolyn VincentJul 27, 2025
How to fix Powermate PFTT142 Tiller engine that is difficult to start?
- A
  Adam HaleJul 27, 2025
  If your Powermate Tiller's engine is hard to start, several factors could be the reason. First, ensure you have fresh fuel in the tank. If the engine switch is off, turn it on. Try pushing the primer 3 times to prime the engine. Check the spark plug wire and ensure it is firmly attached to the spark plug. Inspect the spark plug for fouling and replace it if needed. Also, contaminated fuel can cause starting issues; drain the fuel tank, clean it, and refill with fresh fuel. A clogged air filter can also be the reason, so remove and clean the air filter.
S
sanchezjohnJul 30, 2025
What to do if my Powermate PFTT142 Tiller engine smokes excessively or runs rough?
- J
  Julie CarpenterJul 31, 2025
  If your Powermate Tiller engine smokes too much, runs rough, erratically, or cannot maintain full speed, there are several potential causes. Begin by checking the engine oil level and add oil if it is low, or drain if it is too high. Inspect the spark plug for fouling and replace it if necessary. Also, a clogged air filter can cause these issues, so remove and clean it. Drain the fuel tank, clean it, and refill with fresh fuel to eliminate contaminated fuel as a potential cause.
R
robert97Aug 4, 2025
Why is my Powermate PFTT142 vibrating excessively?
- H
  holly60Aug 4, 2025
  Excessive vibration or noise in your Powermate Tiller can often be attributed to loose parts. Ensure that you tighten all fasteners on the unit. Also, engine problems can cause excessive vibration. Refer to the engine solutions.
W
wilkinsdianeAug 8, 2025
What to do if Powermate Tiller tines will not rotate?
- J
  James MurphyAug 9, 2025
  If the tines on your Powermate Tiller aren't rotating, start by checking for any debris that may be interfering with them and remove it. Also, inspect the tines to ensure they are not loose; replace the tine bolts and nuts if needed. Damaged drive belts can also prevent rotation, so replace them if necessary.
C
carrolltaylorAug 13, 2025
What to do if Powermate PFTT142 tines continue to rotate when lever is not engaged?
- M
  Melissa ThorntonAug 13, 2025
  If the tines on your Powermate Tiller keep rotating even when the lever is disengaged, the drive belts are likely damaged and need to be replaced.
J
Julie HughesAug 17, 2025
Why Powermate Tiller engine will not stop?
- J
  Joshua PowersAug 17, 2025
  If your Powermate Tiller engine won't stop, the issue is likely a faulty switch, which will need to be replaced.
O
orrmaryAug 21, 2025
What to do if Powermate PFTT142 tines will not cut properly?
- P
  Patrick JeffersonAug 21, 2025
  If the tines on your Powermate Tiller aren't cutting properly, it could be due to damaged or worn tines, which will need replacing.

Powermate PFTT142 Specifications

General

Brand	Powermate
Model	PFTT142
Category	Tiller
Language	English

Summary

Safety Definitions

Safety Alert Symbols

Defines symbols used to alert operators to potential safety hazards.

Safety Warning Symbols

Details symbols found on the tiller and their meanings.

Control and Operating Symbols

Explains symbols related to the tiller's controls and operation.

Important Safety Information

Responsibility of Operator

Outlines the operator's duties for safe tiller use and maintenance.

Preparation Safety

Safety precautions to take before operating the tiller.

Operation Safety

Rules and guidelines for safe operation of the tiller.

Fuel Safety

Critical guidelines for safe handling and storage of fuel.

Storage Safety

Procedures for safely storing the tiller, especially for extended periods.

Repair, Maintenance, and Adjustment Safety

Safety measures required during servicing and adjustments.

Children Safety

Specific warnings and precautions regarding children's safety.

Product Specifications

Parts & Features

Safety Decals

Assembly

How to Remove Tiller from Carton

Steps for unpacking and removing the tiller from its packaging.

Attach Wheel Assembly to Frame

Instructions for attaching the tiller's wheel assembly.

Install the Tines

Procedure for mounting the tines onto the tiller axle.

Install the Drag Bar

Steps for installing the tiller's drag bar.

Install Lower Handle

Instructions for attaching the lower handle assembly.

Attach Upper Handle

Procedure for connecting the upper handle to the lower handle.

Install Outside Tine Shields

Steps for fitting the outside tine shields.

Install the Rope Guide

Instructions for installing the engine recoil starter rope guide.

Engine Preparation

Engine Oil

Information on engine oil type, viscosity, and capacity.

How to Check Oil Level and Fill

Critical procedure for checking and maintaining engine oil level.

Operation

Pre-Start Inspection

Essential checklist of checks before starting the engine.

Start the Engine

Step-by-step guide for starting the tiller's engine.

Stop the Engine

Procedure for safely turning off the tiller's engine.

Operating Speed

Information regarding the tiller's fixed throttle setting.

Shutting Down

Steps for safely shutting down the tiller after use.

Transport and Tilling Modes

Instructions on switching between transport and tilling configurations.

Tilling

Guidance on the core process of tilling the soil.

Clutch Lever

Explanation of the clutch lever's function for engaging tines.

Adjustments

General section detailing various adjustments for the tiller.

Drag Bar Adjustment

How to adjust the drag bar to control tilling depth.

Tilling Tips

Advice and techniques for effective soil tilling.

Cultivating Tips

Specific guidance for using the tiller for cultivating.

Maintenance

Maintenance Schedule

Overview of periodic maintenance tasks and intervals.

Important Notes on Maintenance Schedule

Key reminders and notes regarding the maintenance schedule.

Servicing the Tiller

General procedures and checks for servicing the tiller.

Change Belts

Instructions for replacing the drive belts.

Engine Maintenance

Specific maintenance procedures for the tiller's engine.

Check or Fill Engine Crankcase

Procedure for checking and filling the engine oil.

Lubrication

Details on lubricating moving parts at specified intervals.

Clean Tine Axle Shaft

Steps for cleaning debris from the tine axle shaft.

How to Prepare for Storage

Procedures for preparing the tiller for long-term storage.

Technical Service

Troubleshooting

Engine difficult to start

Steps and solutions for resolving engine starting problems.

Engine Problems

Common issues affecting engine performance and operation.

Excessive vibration / noise

How to identify and address unusual vibrations or noise.

Tines will not rotate

Solutions for when the tiller's tines fail to rotate.

Tines continue to rotate when lever is not engaged

Troubleshooting for unintended tine rotation.

Engine will not stop

Steps to resolve issues where the engine cannot be stopped.

Tines will not cut properly

Addressing problems affecting the tines' cutting performance.

Frequent engine stalling

Causes and solutions for the engine frequently stopping.

Warranty

Powermate® ROTARY TILLER Limited Warranty

Details the terms and conditions of the product's limited warranty.

Related product manuals

Powermate PFTT142 User Manual

Table of Contents