4.6.4Inspection and Maintenance of Rear Suspension
1、 It is similar to the front suspension
Check if there exists any distortion or crack on the
install axis of the shock absorber in which case it must
be replaced.
2、 inspect the rocker bushing and the middle rubber separate
is integrant.( According to the front Suspension)
3、 The cotter pin on the head of the install axis which in
the rear shock absorber whether is credible.
Attention,
After disassemble the rear shock absorber, check
if there exists any distortion or crack on the
frame connection hole and the rear shock absorber,
if so, inform the special serviceman to inspect
and service first or install the rear shock
absorber on the frame after instead. (Attention,
the bolts must be the special self-lock nut; the
fastening torque must be 45-55N.m)
4.7. Cooling System of Engine
4.7.1 Disassembly, Inspection and Assembly of Water Cool System
To Next Page