POWX321 EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
7 ASSEMBLY
7.1 Mounting the swivel castors
Remove the motor housing (2).
Turn the tub (5) upside down and insert the swivel castors (7) in the openings creating an
imaginary square while placing them.
Turn the tub upright again.
Re-fit the motor housing.
7.2 Mounting the hose
Insert the hose (8) in the connection (6) and press it on firmly and turn to the right for locking
it into place.
7.3 Fitting and removing the motor housing
The motor housing has been locked to the tub with clamps.
To remove the motor housing (2), first remove the clamps (4) and then lift it from the tub (5).
To re-fit the motor housing, place it on the tub and tighten the damps.
7.4 Fitting the dust filter( FIG B)
A dust back is suitable for collecting small waste material and dust.
Remove the motor housing (2).
Place mesh around filter.
Suspend the dust filter in the tub.
Re-fit the motor housing.
7.5 Mounting the tube to the hose
Connect hose and tube to handle with air valve.
Place the required nozzle on the tail end of the tube.
8 OPERATION
Make sure the power cord has been fully unwound before you switch on the machine. The air
leaving the grids must not be hindered.
When using the machine in combination with an electrical tool, switch on the machine first and
then the electrical tool.
8.1 Switching on and off
To switch the machine on, set the on/off switch (1) to “I”.
To switch the machine off, set the on/off switch (1) to "0".
8.2 Vacuuming up waste material
Check wether the dust filter and paper bag have been fitted.
Mount the tube (10) to the hose (8).
8.3 Vacuuming up dust released from an electrical tool
Check wether the dust filter and paper bag have been fitted.
Connect the hose (8) directly to the dust extraction outlet of the electrical tool.
8.4 Vacuuming up liquids
Check wether the dust filter and paper bag have been removed.
Make sure the inside of the tub (5) is clean and free from dust.
Mount the tube (10) to the hose (8).
To Next Page
Loading...
