To Next PageTo Next Page
Need help?Do you have a question about the Powersmart PS50 and is the answer not in the manual?
General| Brand | Powersmart |
|---|---|
| Model | PS50 |
| Category | Inverter |
| Language | English |
Contact customer service for questions and problems regarding the generator.
Generator engines comply with EPA emission regulations and may have emission control systems.
Generator exhaust contains deadly carbon monoxide gas; use only outdoors.
Product exhaust contains chemicals known to cause cancer or reproductive harm in California.
Generator emits flammable gasoline vapors; avoid open flames and smoking.
Generator produces powerful voltage; ground unit and avoid wet conditions.
Generator surfaces can exceed 150°F; allow to cool before touching.
Misusing the generator can damage it or shorten its life; use as intended.
Connecting to building wiring requires a qualified electrician and transfer switch.
Mix unleaded gasoline with 2-cycle oil at 50:1 ratio for engine operation.
Never store fuel indoors or mix fuel directly in the tank; use ventilated areas.
Fill fuel tank outdoors in a ventilated area, do not overfill, and check for spills.
Properly ground the generator using a grounding wire and rod for electrocution prevention.
Connect AC devices based on their rated and surge wattage requirements.
Determine total device wattage, do not exceed generator capacity, connect devices one at a time.
Use appropriate gauge extension cords based on length and amperage to avoid power loss.
Clean exterior with damp cloth; never clean while running or with water hose.
Clean or replace air cleaner element regularly to maintain proper engine airflow.
Inspect, clean, and gap spark plug for optimal engine operation.
Drain fuel tank annually or before storage to prevent fuel issues.
Store in a cool, dry area; drain fuel for extended periods, change oil.
Drain fuel tank if possible and always keep the generator upright during transport.
Check switch, fuel valve, choke, fuel level, spark plug, surface, and air cleaner.
Check circuit breaker, wiring, device, and generator load to resolve output issues.
