14
WARNING: If the log does not begin to split after 5seconds of operation, release both
controls. The motor or hydraulic fluid may overheat and damage the machine.
Remove a jammed log
WARNING: Do not attempt to remove a jammed log with your hand or try to knock it off the
worktable. Doing so may cause injury and may also damage the splitting wedge.
1. Release the ON/OFF push button (N) and the hydraulic lever (A) to turn off the power and retract the
push rod (B).
2. Insert a wooden wedge (MM, not included) under the jammed log (LL).
3. Activate the push button (N) and the hydraulic lever (A) to start the log splitter and push the wedge
under the log.
4. Release both controls when the log is freed, or when the log is at the height of the wooden wedge
(MM).
5. Repeat steps 3 through 4 until the log is freed.
6. Never try to split logs larger than the rated capacity of the log splitter. Attempting to do so could
result in personal injury and damage to the log splitter.
7. Never place hands or feet between log and splitting wedge or between log and ram during forward or
reverse stroke.
8. Keep clear of moving parts.
9. Do not attempt to split more than one log at one time.
To Next Page
Loading...