Powersmart SF7A202 - Troubleshooting; Product Not Starting; Product Not Reaching Full Power; Unsatisfactory Results and Noise

15
TROUBLE SHOOTING
The following form lists the common operating system with problem and solutions. Please read the form
carefully and follow it.
PROBLEMS
POSSIBLE CAUSES
SOLUTION
Product does not start
1. Not connected to power supply.
2. Power cord or plug is defective.
3. Other electrical defect to the
product.
1. Connect to power supply.
2. Check by a specialist electrician.
3. Check by a specialist electrician.
Product does not reach
full power
1. Extension cord not suitable for
Operation with this product.
2. Power source (e.g. generator) has
too low voltage.
1. Use a proper extension cord.
2. Connect to another power source.
Unsatisfactory result
Cutting attachment is worn.
Replace with a new one
Excessive vibration or
noise
1. Cutting attached is dull / damaged
2. Bolts/nuts are loose.
1. Have it replaced with new one
2. Tighten bolts/nuts.