3
ACCESSORIES:
Step 1: Peel o the plastic film to expose
the non-slip surface of the silicone pads.
Step 3: Secure the battery in place by
fastening the buckle over the battery
pads.
Step 4: Install the battery cables onto
the terminal posts of the battery.
Ensure the red cable is connected to
the positive(+) terminal and both black
cables connected to the negative(-)
terminal. Tighten firmly but be sure not
to over-tighten the battery terminals.
Step 2: Place your battery carefully into
the battery box base, positioning it as
centrally as you can on the non-slip
pads.
Note: the pads may be washed to regain stickiness
To Next Page
Loading...
