OPERATING INSTRUCTIONS
READ THESE INSTRUCTIONS CAREFULLY BEFORE CONNECTING THIS TIMER TO MAINS POWER & YOUR ELECTRICAL APPLIANCES.
IMPORTANT
Don’t plug in any appliance where the load exceeds 10A. Always ensure the plug of the appliance is fully inserted into the timer output. To clean
the timer, remove from the mains power and wipe it with a dry cloth. DO NOT IMMERSE THE TIMER IN WATER OR ANY OTHER LIQUID. The
manufacturer recommends heaters & similar appliances should not be connected to timers as they cannot be left unattended during operation.
FUNCTIONS
1. MASTER CLEAR BUTTON: Clear all data in memory including current time and all programs.
2. UP & DOWN BUTTONS: Set current time with buttons UP, SET & DOWN. Set programs combined with buttons UP, SET & DOWN. Set CD
combined with buttons UP, SET & DOWN. Press UP and DOWN buttons simultaneously to enter CLOCK mode under PROGRAM setting
mode or CD setting mode.
3. SET BUTTON: Set current time combined with buttons SET & UP. Set programs combined with buttons SET & UP. Set CD combined with
buttons SET & UP.
4. RANDOM BUTTON: Set or cancel RANDOM function.
5. CD (COUNTDOWN) BUTTON: Set or cancel CD function.
6. MANUAL BUTTON: Select modes (ON/AUTO/OFF) of timer & override programs or recall the overridden programs in setting programs.
FEATURES
• 10 On/Off programs with 1 minute step
• Manual On/Auto/Manual Off
• 12/24 hour mode, summertime & random (turns on 10-31 minutes between 6:00PM and 6:00AM) functions selectable
• Maximum of 99 hours 59 minutes 59 seconds CD (COUNTDOWN) function
• 16 combinations of single days or blocks of days available as follows:
FUNCTION DAY COMBINATIONS
MO Monday
TU Tuesday
WE Wednesday
TH Thursday
FR Friday
SA Saturday
SU Sunday
MO, TU, WE, TH, FR, SA, SU Full week
MO, TU, WE , TH, FRI Monday - Friday
SA, SU Saturday & Sunday
MO, TU, WE, TH, FRI, SA Monday - Saturday
MO, WE, FRI Monday, Wednesday, Friday
TU, TH, SA Tuesday, Thursday, Saturday
MO, TU, WE Monday, Tuesday, Wednesday
TH, FRI, SA Thursday, Friday, Saturday
MO, WE, FR, SU Monday, Wednesday, Friday, Sunday
INITIAL OPERATION
1. Plug the timer into a regular 240V power outlet and turn the power on. Leave for approximately 14 hours to charge the back-up battery.
2. Clear all current information by pressing the MASTER CLEAR button with a sharp object such as a pen or pencil after charging.
3. The timer is now ready to be set-up for use.
SETTING CURRENT TIME
1. Press the UP button or the DOWN button until the CLOCK icon displays on-screen.
2. Press the SET button for 2 seconds until “SET” displays on-screen and flashes. The “WEEK DAY” icon will flash at the same time. The timer
has changed to SET mode, so you can set the current time now.
3. Press the UP button or the DOWN button to set the “WEEK DAY”.
4. Press the SET button once and release. The “HOUR” will flash, the “WEEK DAY” will stop flashing and remain on-screen.
5. Press the UP button or the DOWN button to set the “HOUR”.
6. Press the SET button once time and release. The “MINUTE” will flash, the “HOUR” will stop flashing and remain on-screen.
7. Press the UP button or the DOWN button to set the “MINUTE”.
8. Press the SET button once time and release, the time change to CLOCK mode.
9. To reset the incorrect time, repeat above steps.
MS-6114
To Next Page
Need help?
Power
Operating Environment
Battery
